Mature oil reservoirs surrounded with strong edge and bottom water drive aquifers experience pressure depletion and water coning/cresting. This laboratory research investigated the effects of bottom water drive and gas breakthrough on immiscible CO2-Assisted Gravity Drainage (CO2-AGD), focusing on substantial bottom water drive. The CO2-AGD method vertically separates the injected CO2 to formulate a gas cap and Oil. Visual experimental evaluation of CO2-AGD process performance was performed using a Hele-Shaw model. Water-wet sand was used for the experiments. The gas used for injection was pure CO2, and the “oleic” phase was n-decane with a negative spreading coefficient. The aqueous phase was deionized water. To evaluate the feasibility of the CO2-AGD process without any bottom water drives, it was first used. The experimental results demonstrated that existence of bottom water drive affected oil recoveries due to pressure support. Oil recovery before gas breakthrough increases proportionally with bottom water drive intensity. The gas breakthrough time recoveries for CO2-AGD1, CO2-AGD2, and CO2-AGD3 runs were 38.68%, 50.70%, and 60.85% of OOIP. The pressure gradient along the physical model decreases as bottom water drive intensity increases. The CO2-AGD approach delayed gas breakout by 72 min. As aquifer strength increases, gas breakthrough is delayed. In the three CO2-AGD runs and after breakthrough occurrence, the injector-producer pressure difference decreased due to the residual heads of oil and water columns above the horizontal well. As long as oil and water exist in the model, the pressure differential will not be zero, and the relative permeability and capillary trapping also control this phenomenon. Finally, it was demonstrated that there is a direct correlation between the strength of the aquifer and the oil recovery factor. The strength of the aquifer positively affects the oil recovery at breakthrough and the ultimate oil recovery.
Abstract:
Due to the importance of technology and the accompanying changes of the environment affecting companies that use the technology mainly in their work, especially as most companies live in an unstable dynamic environment, which motivated the researchers to choose the International Company for smart card (Keycard) as a field of research and find ways to them to face Those changes.
The problem of the study was "limited attention to the components of technological change", which included research and development, innovation and information technology, which had an impact on the design decisions of the process (process selection, cust
... Show MorePseudomonas aeruginosa and Klebsiella pneumoniae appears good growth when replicate to culture with heavy crude oil. K. pneumoniae was less ability to biodegrade the heavy crude oil (66.22 wt.%) compare with P. aeruginosa 74 wt.%). Also the emulsion percent were about 64.8 % and 62.5 % for K. pneumoniae and P. aeruginosa, respectively. The results showed that the emulsions produced from both the strains decrease the surface tension of the media from 68.43 Mn/m (for control sample) to 44.50 and 43.30 Mn/m for P. aeruginosa and K. pneumoniae, respectively. The optimum temperature and pH for the hydrocarbons biodegradation were 28 ºC and 7, respectively. The incubation period of 28 days of the isolated increased hydrocarbons biodegradation
... Show MoreAnkylosing spondylitis (AS) represents one kind of advanced arthritis formed via inflammatory stimuli long-term in the spin‘s joints. Interleukin (IL)-29 (interferon- lambda1(IFN- λ1)), interleukin (IL)-28A (interferon- lambda 2 (IFN- λ2)) and interleukin (IL)-28B (interferon- lambda 3(IFN-λ3)) are three interferon lambda (IFN- λs) molecules that have recently been identified as new members of the IFN family. IL-28B expression in ankylosing spondylitis (AS) is not well understood. 150 male healthy controls ((HC) and 160 males with AS as patients group participated in this study. Serum level and gene polymorphism were assessed using an enzyme-linked immunosorbent assay and Sanger sequencing for IL-28B, respectively. The results showed
... Show More
Mixed convection heat transfer to air inside an enclosure is investigated experimentally. The bottom wall of the enclosure is maintained at higher temperature than that of the top wall which keeps in oscillation motion, whereas the left and right walls are well insulated. The differential temperature of the bottom and top walls changed several times in order to accurately characterize the temperature distribution over a considerable range of Richardson number. Adjustable aspect ratio box was built as a test rig to determine the effects of Richardson number and aspect ratio on the flow behavior of the air inside the enclosure. The flow fields and the average Nusselt number profiles were presented in this wo
... Show MoreIn this study ZnS thin film was prepared by using thermal evaporation vacuum technique under the pressure (10-6) Torr on glass substrate at room temperature and annealing at 523 K Samples were irradiated to CO2 laser of power (1 watt) and wave length (10.6) μm at distance 10 cm from the source during (5 sec). The absorbance spectra was recorded by using UV-visible spectrophotometer and used to calculated some of optical properties investigated including their transmittance, reflectance spectra, energy gap, and extinction coefficient. From the result of thin films samples at room temperature and at 523 K, we conclude that the irradiation by laser causes a decrease in the transmittance and increasing in reflection and extinction coeffic
... Show MoreThis study aims to figure out how to calculate water recharge using the soil conservation service method, one of the most widely used methods for calculating runoff volume following rainfall. The research is being conducted in Ameriat Al-Falluja City, Al-Anbar Governorate. The Iraqi meteorological organization's Baghdad Airport and Al-Ramadi stations provided data on the research area from 1989 to 2020 as total annual rainfall (123.1 mm), the RH% (43%), the mean monthly T (23.6 °C), total evaporation (3169.61 mm), the wind speed (3.1 m/s), and the sunshine duration (9 h/day). The climate of the study area is described as arid. The total evapotranspiration value quantity is 1137.38 mm for the 32-year comparison period, while the
... Show MoreWe report on using a CO2 (10.6 µm) laser to debond the lithium disilicate veneers. Sixty-four sound human premolar teeth and 64 veneer specimens were used in the study. The zigzag movement via CO2 laser handpiece along with an air-cooled jet to prevent temperature elevation above the necrosis temperature limit (5.5 C°) was applied. The optimal deboning irradiation time was super-fast, at about 5 seconds at 3 Watt CO2 laser power. It is 20 times less than any previously published work for veneers debonding. The enamel beneath the debonded veneers has been assessed by atomic force microscopy (AFM) and shear stress technique as criteria for the easiness of debonding. The
... Show More
An automatic text summarization system mimics how humans summarize by picking the most significant sentences in a source text. However, the complexities of the Arabic language have become challenging to obtain information quickly and effectively. The main disadvantage of the traditional approaches is that they are strictly constrained (especially for the Arabic language) by the accuracy of sentence feature functions, weighting schemes, and similarity calculations. On the other hand, the meta-heuristic search approaches have a feature tha
... Show MoreWater supply and distribution networks play an important role in our daily activities. They make a substantial contribution to public health by providing potable water for public consumption and non-potable applications such as firefighters and other purposes such as irrigation. This study used ArcMap 10.8 and WaterGEMS CONNECT Edition update 1 version to create a hydraulic network model to simulate the pipes’ network. Detailed network information, including pipe lengths, layouts, and diameters, was given by the Baghdad Water Department. The TUF-2000H Handheld digital ultrasonic flow meter has been used to measure the water flows in the network’s source nodes. In eight junctions,