The study was conducted in the Tigris River in Baghdad during May 2021 until March 2022 to follow the impact of climate change, rising temperatures, and the presence of pollutants on the dynamics of phytoplankton and some physicochemical variables from four sites. The results showed that the climatic conditions during different seasons, in addition to the nature of the sampling sites, have a clear and significant impact on the studied traits and, in turn, affect the phytoplankton community. The highest average temperature (30.67 ˚C) was recorded; the pH values ranged between 8.70 & 6.75; the electrical conductivity (1208.18-770.11 µS/cm ) and the total dissolved solids (TDS) (778.95- 439.49 mg/L) were evaluated. Upon measuring the total hardness and turbidity, a significant increase was detected at the third site during winter, amounting to 67.26 NUT and 775.46mg/ L, respectively. The dissolved oxygen concentration (DO) was recorded at the fourth site during winter (10.08- 4.67 mg/L), while the BOD ranges were 4.87- 2.51mg/ L. A benefit in the average values of plant nutrients was detected at the third site affected by the waste liquid disposal area of the Medical City Hospital Complex compared to the nutrient concentration at the other three sites, which was 3.43, 4.87, 13.50 & 409.00mg/ L for NO3 PO4 and SiO2 and S04, respectively, The study was able to classify 161 species of phytoplankton belonging to 69 genus, the largest percentage of which was Baciliariophyceae (42%), followed by Cyanophyceae (27%), Chlorophyceae (24%), Euglenophyceae (4%) and 1% for Chrysophyceae, Xanthphyceae, and Cryptophyceae. Recent years have witnessed severe climatic conditions affecting various environmental factors in the study area. The phytoplankton community has been vulnerable to their impact altering the physical and chemical properties of the river water. This indicates that the aquatic environment responds to climatic conditions.
Acuaria skrjabini Ozerskaya, 1926 and Dispharynx nasuta (Rudolphi, 1819) Stiles and Hassall, 1920, were found embedded in the mucosa of the gizzards of 26.97% of house sparrows, Passer domesticus biblicus collected in Baghdad City. Their morphometric and meristic features were expressed and compared with that reported in other studies.
This work deals with the nematode parasitesfrom the midgut of (16) specimens of Green
toad (Bufo viridis) Laurenti, 1768 collected from Baghdad area,central Iraq.
The parasites are:Cosmocercoides variabilis (Cosmocercidae) that considered as the first
report in Iraq on it and Oswaldocruzia filiformis (Molineidae).
The aim of this research is to study the influence of additives on the properties of soap greases, such as lithium, calcium, sodium, lithium-calcium grease, by adding varies additives, such as graphite, molybdenum disulfide, carbon black, corrosion inhibitor, and extreme pressure.
These additives have been added to grease to obtain the best percentages that improve the properties of grease such as load carrying, wear resistance, corrosion resistance, drop point, and penetration.
The results showed the best weight percentages to all types of grease which give good properties are 1.5% extreme pressure additive, 3% graphite, 1% molybdenum disulfide, 2.5% carbon black.
The other hand, the best weight percentage for corrosion inhibit
For the past few years, the sediment began to accumulate in Al-Gharraf River which reduces the flow capacity of the River. In the present research, a numerical model was developed using Hec-Ras software, version 5.0.4. to simulate the flow and sediment transport in the upper reach of the river. The hydrological and cross-section data measured by the Ministry of Water Resources, for the reach located between Kut and Hai cities and having a length of 58200 m, was used to perform calibration and verification of the model. Moreover, field sampling of suspended and bed loads was gathered for five months starting from 7/2/2019, and laboratory tests of samples were conducted to be used as in
Total Quality Assurance Concept have appeared in Higher Education Institutions as a result of the continuous criticism for the lower quality of the outputs of these institutions and their inappropriacy to the needs of the job market. The faculty, i.e. teaching staff member, is one of the most important output for his/her responsibility to achieve the stated goals in higher education. This represents a problem that may influence the construction of society which has to limit his tasks, responsibilities, and competencies that should be found in a faculty, and evaluating his teaching profession in light of the prerequisites of the century to become an input to achieve quality assurance in Higher Education. Therefore, the present study aims
... Show MoreContents IJPAM: Volume 116, No. 3 (2017)
Vitamin D is one of several nutrients essential for calcium metabolism. Body weight status and magnesium may influence vitamin D activity. To determine whether salivary vitamin D, magnesium, and calcium levels are associated with body weight status and dental caries severity in children, this cross‐sectional research was conducted.
The sample consisted of 180 boys aged 6–8 years. According to their body mass index (BMI), children were assigned to three groups of 60 boys (normal weight, overweight, and obese). Moreover,
This work examines numerically the effects of particle size, particle thermal conductivity and inlet velocity of forced convection heat transfer in uniformly heated packed duct. Four packing material (Aluminum, Alumina, Glass and Nylon) with range of thermal conductivity (from200 W/m.K for Aluminum to 0.23 W/m.K for Nylon), four particle diameters (1, 3, 5 and 7 cm), inlet velocity ( 0.07, 0.19 and 0.32 m/s) and constant heat flux ( 1000, 2000 and 3000 W/ m 2) were investigated. Results showed that heat transfer (average Nusselt number Nuav) increased with increasing packing conductivity; inlet velocity and heat flux, but decreased with increasing particle size.Also, Aluminum average Nusselt number is about (0.85,2.
... Show MoreIn this study, composite materials were prepared using unsaturated polyester resin as binder with two types of fillers (sawdust and chopped reeds). The molding method is used to prepare sheets of UPE / sawdust composite and UPE / chopped reeds composite. The mechanical properties were studied including flexural strength and Young's modulus for the samples at normal conditions (N.C). The Commercial wood, UPE and its composite samples were immersed in water for about 30 days to find the weight gain (Mt%) of water for the samples, also to find the effect of water on their flexural strength and Young's modulus. The results showed that the samples of UPE / chopped reeds composite gained highest values of flexural strength (24.
... Show More