This paper presents a study (experimentally) for strengthening reinforced concrete (RC) beams with Near-Surface-Mounted (NSM) technique. The use of this technique with CFRP strips or rebars is an efficient technology for increasing the strength for flexure and shear or for repairing damaged reinforced concrete (RC) members. The objective of this research is to study, experimentally, RC beams either repaired or strengthened with NSM CFRP strips and follow their flexural behavior and failure modes. NSM-CFRP strips were used to strengthen three RC beam specimens, one of them was initially strengthened and tested up to failure. Four beam specimens have been initially subjected to preloading to 50% and 80% of ultimate load. Two of the specimens were either repaired or strengthened with NSM-CFRP strips. All the repaired/strengthened pre-damaged beams have been tested up to failure by using compression-testing machine. An appropriate-scale model was adopted. All the specimens have a cross-sectional dimension of 150 mm with an effective span of 110 mm. Depends on the experimental results, a better performance of the strengthened concrete specimens was obtained in both strength and serviceability. As a comparison with the control beam specimen, all the repaired specimens show a very good increase of about 40% in the load-carrying capacity and a high improvement in resistance to cracking of about 120% in NSM. On the other hand, the test results of NSM CFRP-strengthened concrete specimens with a preloading of 50% and 80% of the ultimate load show an increase of about 9% to 20% in the load-carrying capacity, for 50% and 80% pre-loading, respectively an improvement in deflection of about 2% to 27% in NSM, for 80% and 50% pre-loading, respectively.
This was study conducted to evaluate the efficacy of the secondary metabolites from produced Metarhizium anisopliae in potato sucrose broth, rice broth and wheat broth, against larvae and adults of Chysomya albiceps. Results showed that filtrate of potato broth was better in mortality rates occurrence when second instar larvae were treated, the mortality rate was 46.67%. While the treatment of the larvae using the filter of rice and wheat broth gave total accumulated mortality rate (larvae and pupae) of 36.67 and 40.00 respectively. While it was 66.76 when treated with potato broth adults food with filtrate recorded high mortality rate reached to 90.00% after one week.
A comprehensive practical study of typical mechanical properties of welded Aluminum alloy AA7020-T6 (Al-Mg-Zn), adopting friction stir welding (FSW) technique and conventional metal inert gas (MIG) technique, is well achieved in this work for real comparison purposes. The essences of present output findings were concentrated upon the FSW samples in respect to that MIG ones which can be summarized in the increase of the ultimate tensile strength for FSW was 340 MPa while it was 232 MPa for MIG welding, where it was for base metal 400 MPa. The minimum microhardness value for FSW was recorded at HAZ and it was 133 HV0.05 while it was 70 HV0.05 for MIG weld at the welding metal. The FSW produce 2470 N higher than MIG welding in the bending t
... Show MoreIn this research we prepared CdS thin films by Spray pyrolysis method on a glass substrates and we study its structural , optical , electrical properties .The result of (X-Ray ) diffraction showed that all thin films have a polycrystalline structure , The relation of the transmission as a function of wavelength for the CdS films had been studied , The investigated of direct energy gap of the CdS its value is (2.83 eV). In Hall effect measurement of the CdS we find the charge carriers is p – type and Hall coefficient 1157.33(cm3/c) ,Hall mobility 6.77(cm2/v.s)
The hydrochemical study of the surface and groundwater in Khan AL-Baghdadi area included interpretation of physical, chemical and biological properties of 14 wells and 6 surface water samples collected from Euphrates River.. The study covered two periods representing dry and wet periods in October 2018 and April 2019, respectively. The surface water samples were characterized as slightly alkaline, fresh water, excessively mineralized, calcium-chloride type, and hard to very hard class. While the groundwater samples were characterized as slightly alkaline, brackish water, excessively mineralized, calcium-chloride and sodium-chloride type, and hard to very hard class. The assessment of water for irrigation purposes for bo
... Show MoreThis study was carried out to investigate the possibility of chickpea soaked water as a substitute for yeast in dough fermentation and its effects on sensory properties of the laboratory loaf bread. Chickpea was soaked for 24,48 and 72 hours at room temperature and used in proportion with or without yeast in dough fermentation . The results revealed that , as the percentage of soaked chickpea water substitution increased, the volume of the produced loaf bread decreased as compared with the control treatment (only yeast ).Best results were obtained by using soaked chickpea water for 24 hours in proportion of 1:1 soaked chickpea water : yeast regarding the sensory properties ,volume and leavening of the loaf bread.
Keywords: chickpea so
ملخص البحث
يعد البيت المكان الاجتماعي الأول الذي تبنى فيه الصحة النفسية لدى الفرد منذ بداية حياته كطفل في ظل أسرته ، إلا أن الروضة تمتلك على الرغم من ذلك أثراً تكوينياً مهماٌ في حياة الطفل وعلى شخصيته ، والتي لا يمكن ان يقلُّ عن أثر الايجابي للبيت ؛ ذلك أن المفهوم الجديد لدور الروضة لا يقتصر بمجرد كونها مكانًا تقوم فيها المعلمة بتزويد الاطفال بالمعر
... Show MoreThe specifications of lubricating oil are fundamentally the final product of materials that have been added for producing the desired properties. In this research, spherical nanoparticles copper oxide (CuO) and titanium oxides (TiO2) are added to SAE 15W40 engine oil to study the thermal conductivity, stability, viscosity of nano-lubricants, which are prepared at different concentrations of 0.1%, 0.2%, 0.5%, and 1% by weight, and also their pour point, and flash point as five quality parameters. The obtained results show that CuO nanoparticles in all cases, give the best functionality and effect on engine oil with respect to TiO2. With 0.1 wt. % concentration, the thermal conductivity of CuO/oil and TiO2/
... Show MoreThe city of Baghdad has recently witnessed an increase in urban land due to the recent economic growth, which negatively affected the environment of the study area through the retraction of the agricultural lands surrounding the city. Therefore, we studied the relationship between increasing urban expansion and changes in the local climate of Baghdad for the period from 2008 to 2018. The information derived from the satellites utilized in this search showed the changes in ground cover during the study period, while the evaporation rate data source from the European Center for Forecasting (ECMWF) confirmed the effects of urban expansion on evaporation rates. Increasing urbanization increased evaporation rates and decreased vegetation degr
... Show MoreThe process of digital transformation is considered one of the most influential matters in circulation at the present time, as it seeks to integrate computer-based technologies into the public services provided by companies or institutions. To achieve digital transformation, basics and points must be established, while relying on a set of employee skills and involving customers in developing this process. Today, all governments are seeking electronic transformation by converting all public services into digital, where changes in cybersecurity must be taken into account, which constitutes a large part of the priorities of nations and companies. The vulnerability to cyberspace, the development of technologies and devices, and the use
... Show More