To verify the influence of magnetic flux on the characteristics of SAE 10W-30 gasoline engine oil when the engine oil is exposed to different magnetic fluxes 0, 6, 9, and 13 Volt. The following oil characteristics were measured: viscosity at 40 and 100 °C, and total acid number (TAN) mg KOH/g. The research was carried out in a completely randomized design with three replications for each treatment under the 5% probability level to compare the means of the treatments. The results of the experiment showed that there were significant differences in the studied properties when the engine oil was exposed to the above magnetic fluxes and, inversely, especially the magnetic flux of 13 Volt, which led to a decrease in the viscosity of the oils at

This work aims to provide a statistical analysis of metal removal during the Magnetic Abrasive Finishing process (MAF) and find out the mathematical model which describes the relationship between the process parameters and metal removal, also estimate the impact of the parameters on metal removal. In this study, the single point incremental forming was used to form the truncated cone made of low carbon steel (1008-AISI) based on the Z-level tool path. Then the finishing was accomplished using a magnetic abrasive process based on the Box-Behnken design of the experiment using Minitab 17 software was used to finish the surface of the formed truncated cone. The influences of different parameters (feed rate, machining step s

A piezoelectric cantilever beam with a tip mass at its free end is a common energy harvester configuration. This article introduces a new principle of designing such a harvester that increases the generated power without changing the resonance frequency of the harvester: the attraction force between two permanent magnets is used to add stiffness to the system. This magnetic stiffening counters the effect of the tip mass on the efficient operation frequency. Five set-ups incorporating piezoelectric bimorph cantilevers of the same type in different mechanical configurations are compared theoretically and experimentally to investigate the feasibility of this principle: theoretical and experimental results show that magnetically stiffened harve

Magnetic plaster kiln dust (MPKD) was synthesized as a unique, low-cost composite reused of byproduct plaster kiln dust (PKD), which is considered a source of air pollution. The FESEM, EDS, XRD, FTIR, VSM, and BET tests were used to characterize the MPKD. The characterization revealed that the MPKD was nanotubes non-agglomerated and super-paramagnetic with a high specific surface area (102.7 m²/g). Compared with the specific area of other materials (composites), the MPKD could be considered a promising substance in the field of water/wastewater treatment.

Drug –induced nephrotoxicity is an important cause of renal failure. Aminoglycoside antibiotics, such as amikacin, which causes ototoxicity and nephrtotoxicity as a main side effects, this is focused on the use of natural materials as antioxidants against the toxic oxidative action that exert a cell damaging effect. The most important one of these materials is the honey. The aim of this work is to evaluate the antioxidant effects of honey against amikacin – induced nephrotoxicity.18 albino rats divided into 3 groups (6 rats per each group), group 1 received I.P daily dose of normal saline (control), group 2 received (35  mg/kg/day) I.P dose of amikacin ,and group 3 received (35mg/kg/day) of amikacin I.P dose in combina

Drug-induced acute kidney injury is a serious disorder. Oxidative stress has a key role in its initiation and progression. In this study, the possible ameliorative effect of fimasartan against methotrexate-induced nephrotoxicity was investigated in comparison with α-tocopherol in rats. Wistar rats were allocated into six groups and treated as follows: group Ӏ received water on a daily basis for 8 successive days; group ӀӀ received methotrexate (20 mg/kg) on day 1, followed by water for 7 successive days; group ӀӀӀ received fimasartan (3 mg/kg/day) for 7 successive days; group IV received α-tocopherol (1 g/kg/day) for 7 successive days; group V re