The method of powder technology has been utilized in fabrication of machinable
ceramics by the approach of glass-ceramic principles. The crystalline ceramic phases
partially dissolved by host glass while the undissolved part remain responsible for the
machinability by the usual cutting tools. Thus avoiding the unnecessary use of special
dies to cast fully melted composition and initiate recrystallization process. Two types of
machinable ceramics have been successfully prepared, the first with high silica content
and the other with high alumina content. A comparison of their properties and discussed.

يهدف البحث الى بيان اثر تقييم المشاريع الاستثمارية في تطوير واعداد الموازنات الاستثمارية المعدة من قبل الوحدات الاقتصادية حيث ان المشاريع الاستثمارية تعد ذات طابع مهم وحيوي للوحدات الاقتصادية وذلك لما تتضمن هذه المشاريع من طول الفترة الزمنية للاعدادها وتنفيذها ولما يرافق هذه الفترة من مخاطر وعدم تأكد وكذلك احتياجها الى اموال كثيرة لأنجاز المشروع, فأن عملية تقييم المشاريع المنفذة والتي تم اعداد موازنة

New technologies have risen into popularity causing the Liquid membrane techniques to evolve over other separation techniques due to its high selectivity and recovery, increased fluxes, and reduced investment and operating cost. This work focuses on extracting Methylene Blue (MB), a cationic dye using a simple BLM separation technique from its aqueous phase. It combines extraction and stripping in a single unit operation. The feed phase was an aqueous solution of MB, the solvent chosen was soybean oil for the liquid/organic membrane phase, and tri-octyl amine acted as a carrier. The strip phase was a hydrochloric acid solution for this study. A two-phase equilibrium study was done to choose the correct solvent, carrier,

The biochar prepared from sawdust raw material was applied in this study for the treatment of wastewater polluted with methyl orange dye. The effect of pH (2-11), initial concertation (50-250 mg/L) and time were studied. The isotherm of Langmuir, Frendluch and temkin models studied. The Langmuir model was the best to explain the adsorption process, maximum uptake was 136.67 mg/g at 25C^o of methyl orange dye. Equilibrium reached after four hours of contact for most adsorbents.The values of thermodynamic parameters ∆G were negative at various temperatures, so the process spontaneous, while ∆H values were 16683 j/mol and ∆S values was 60.82 j/mol.k.

Adsorption experiments were carried out using two different low-cost sorbent materials, date seeds and olive seeds. These sorbents used as a single phase (not as mixture) to remove cadmium ions from simulated wastewater by adsorption process. The equilibrium time was found at 2 hr. The experiments include different parameters such sorbent type and weight and contact time. It was found that both of olive seed and date seed have approximately the same adsorption capacity (qm) with 15.644 mg/g and 15.2112 mg/g, respectively. Equilibrium isotherms and kinetic studies have been carried out. Langmuir isotherm model better fits the experimental data compared with the Freundlich isotherm for olive seed, while Freundlich isotherm fits for date se

Pollutants generation is strongly dependant on the firing temperature and reaction rates of the gaseous reactants in the gas turbine combustion chamber. An experimental study is conducted on a two-shaft T200D micro-gas turbine engine in order to evaluate the impact of injecting ethanol directly into the compressor inlet air on the exhaust emissions. The study is carried out in constant speed and constant load engine tests. Generally, the results showed that when ethanol was added in a concentration of 20% by volume of fuel flow; NO_x emission was reduced by the half, while CO and UHC emissions were almost doubled with respect to their levels when burning conventional LPG fuel alone.