Experimental investigations had been done in this research to demonstrate the effect of carbon fiber and Ceramic fillers contents on the tribological behaviour of (15% volume fraction) carbon-epoxy composite system under varying volume fraction, load, time and sliding distance. The wear resistance were investigated according to ASTM G99-05standard using pin on disc machine to present the composite tribological behaviour. The influence of three ceramic fillers, granite, perlite and calcium carbonate (CaCO3), on the wear of the carbon fabric reinforced epoxy composites under dry sliding conditions has been investigated. The effect of variants in volume fraction, applied load, time and sliding distance on the wear behaviour of polymer composites is studied by measuring the weight changes . In the experiments with wear test pin having flat face in contact with hardening rotating steel disc, sliding speed, time and loads in the range of 200 RPM, 300–900s and 40–60 N respectively was used. It is observed that the wear resistance increase with the increasing of reinforcement material volume fraction while, the wear rate increases with increasing of applied load, time and sliding distance. The results showed that the filler of granite perlite and CaCO3 as filler materials in carbon epoxy composites will increase the wear resistance of the composite greatly than carbon fiber fillers epoxy composite only and granite filled CE Composite exhibited the maximum wear resistance.
It is an established fact that substantial amounts of oil usually remain in a reservoir after primary and secondary processes. Therefore; there is an ongoing effort to sweep that remaining oil. Field optimization includes many techniques. Horizontal wells are one of the most motivating factors for field optimization. The selection of new horizontal wells must be accompanied with the right selection of the well locations. However, modeling horizontal well locations by a trial and error method is a time consuming method. Therefore; a method of Artificial Neural Network (ANN) has been employed which helps to predict the optimum performance via proposed new wells locations by incorporatin
The research material was prune plums (
Dermatophytes are species with slight genetic variation, and are yet several uncertainties about the differences among species. This study aims to isolate and diagnose the Trichophyton interdigitale by molecular technique and to reveal the phylogenetic distance and similarity of the Iraqi isolates to other isolates from the globe, in addition, to submit the obtained sequences to the NCBI database. This study included 86 with multiple lesions on different parts of the body. The results showed different variations within the ITS gene between the isolates. It was concluded that Trichophyton interdigitale in Iraqi isolates had two types of substitution variations (Transition and Transversion) different than global isolates. Moreover, it
... Show MoreIn this work, monitoring of monthly variation (from May 2016 to October 2016) in the concentration of the metals (Co, Zn, Cd, Pb, Ni and Fe) from Al-Diwaniya city of Iraq. Investigation about the pollution with these metals was achieved from five selected sites locate in study area by flame atomic absorption spectroscopy. The results showed a wide variation in the levels of heavy metals from site to site and from month to month. A total of 180 surface soil samples were analyzed to detecting the pollution with selected samples. The resultsshowed that the highest concentration with Ni was 6.290 mg kg-1 while the lowest concentration detected with Ni was 0.080 mg kg-1. The results of pollution index (enrichment factor, contamination factor, po
... Show MorePiezoelectric structures are nowadays used in many different applications. A better understanding of the influence of material properties and geometrical design on the performance of these structures helps to develop piezoelectric structures specifically designed for their application. Different equivalent circuits have been introduced in the literature to investigate the behaviour of piezoelectric transducers. The model parameters are usually determined from measurements covering the characteristic frequencies of the piezoelectric transducer. This article introduces an analytical technique for calculating the mechanical and electrical equivalent system parameters and characteristic frequencies based on material properties and geom
... Show MoreIntroduction and Aim: Beta-thalassemia is a serious inherited genetic disorder and an increasing health burden globally. Beta -thalassemia is caused by genetic globin abnormalities within the hemoglobin beta (HBB) gene. This study aimed to characterize the HBB gene mutations in beta -thalassemia among southern Iraqi patients. Materials and Methods: The study included 30 beta -thalassemia patients referred to the Thi-Qar Center for Genetic Diseases, Iraq and 15 control samples from a random group of apparently healthy individuals. Genomic DNA was isolated from blood sample collected from each individual. The DNA was amplified for specific regions of the HBB gene and the amplified products sequenced. The sequences generated were analysed for
... Show MoreThis study was designed to identify the extent of the effect of drug Acetylsalicylic acid (aspirin) on histological structure of liver in Swiss albino mice Mus musculus.(16) mice were used and divided into two groups. The first groupwas orally treated with )0.5ml(of aspirinat concentration of (50 mcg / kg) and the second group was considered as control group Treated with distiled water lasted for 30 days. Treatment with Aspirin led to the occurrence of histopathological cases included liver necrosis ,cellular infilitration, congestion in central vein and a case of Hemorrhage. The results also showed the absence of radial arrangement of the constituents of hepatic cells from tissue due to these changes with the control group.
... Show More