The utilization and incorporation of glass fiber-reinforced plastics (GFRP) in structural applications and architectural constructions are progressively gaining prominence. Therefore, this paper experimentally and numerically investigates the use of GFRP I-beams in conjunction with concrete slabs to form composite beams. The experimental design incorporated 2600 mm long GFRP I-beams which were connected compositely to concrete slabs with a 500 mm width and 80 mm thickness. The concrete slabs are categorized into two groups: concrete slabs cast using normal-strength concrete (NSC), and concrete slabs prepared using high-strength concrete (HSC). Various parameters like the type of concrete (normal and high-strength concrete), type of stiffeners bonded to the composite section (bolt–epoxy or bolt only), and inclusion of corrugated metal sheets were investigated. To obtain the full shear connection between the GFRP I-sections and concrete slabs, two rows of shear connectors in the form of bolts were utilized. These shear connectors were erected to the top flange of the GFRP I-sections to compositely connect between the GFRP I-beams and the concrete slabs as well as the corrugated metal sheets. The strengthening of the shear webs of GFRP I-beams with GFRP T-section stiffeners resulted in an enhancement in the flexural and shear strength. The failure loads in the case of the bolt–epoxy connection for the stiffeners were 8.2% and 10.0% higher than those in the case of bolt only when the concrete compressive strengths were 20.1 MPa and 52.3 MPa, respectively. Moreover, the effect of the concrete compressive strength was vital where the failure loads increased by 79.9% and 77.1% when HSC was used instead of NSC for the cases of bolt–epoxy and bolt only, respectively. The epoxy adhesive used in conjunction with mechanical connectors, specifically bolts, resulted in sufficient composite action and delayed shear failure within the web of the GFRP beam. For the specimens with bolt–epoxy connection, strain levels in the concrete slabs were consistently higher than in the other specimens with bolts alone at the same loading level. The concrete slabs integrated with HSC registered strain levels that were 20.0% and 21.8% greater for bolt–epoxy and bolt-only connections, respectively, when compared to those using normal-strength concrete (NSC). This discrepancy can likely be credited to the enhanced composite interaction between the concrete slabs and the GFRP I-beams. In addition, ABAQUS software (version 6.2) was used to develop FE models to analyze the tested composite beams and provide a parametric study using the verified models.
Adipokines are associated with insulin resistance and obesity-related metabolic
disorders in many diseases. The levels of Lipocalin-2 and Retinol binding protein-4
were evaluated in sera of patients with Type 2 diabetes (T2DM) to study the
association between them and the inflammatory state as established by high levels of
C - reactive protein and with atherogenicity. Serum Lipocalin-2 and Retinol binding
protein-4 levels measured in 73 subjects: 48 patients with T2DM with the mean
level of C- reactive protein 23.989 mg/dL. For comparison, 25 age- and gendermatched
control participants enrolled with C- reactive protein CRP level 1.476
mg/dL. The results showed that circulating Lipocalin-2, and Retinol binding prot
An essential issue in obstetrics is the prevalence of maternal and fetal complications in pregnant women with polycystic ovary syndrome (PCOS). The purpose of the present study was to investigate the prevalence of pregnancy complications among various phenotypes of pregnant women with PCOS.
six specimens of the Hg0.5Pb0.5Ba2Ca2Cu3-y
Two-dimensional unsteady mixed convection in a porous cavity with heated bottom wall is numerically studied in the present paper. The forced flow conditions are imposed by providing a hydrostatic pressure head at the inlet port that is located at the bottom of one of the vertical side walls and an open vent at the top of the other vertical side wall. The Darcy model is adopted to model the fluid flow in the porous medium and the combination effects of hydrostatic pressure head and the heat flux quantity parameters are carefully investigated. These governing parameters are varied over wide ranges and their effect on the heat transfer characteristics is studied in detail. It is found that the time required to reach a desired temperature at th
... Show MoreObjective: Pregnancy-induced hypertension (PIH) is a major pregnancy complication that leads to maternal mortality. Here, we have scrutinized the correlation between serum levels of hydrogen peroxide (H2O2) and superoxide dismutase (SOD) in PIH.Methods: Serum samples were collected from 80 Iraqi women (40 women with PIH as patients group, 20 normotensive pregnant women as a positive control, and 20 normotensive non-pregnant women as a negative control) all groups were diagnosed clinically.Results: Serum of H2O2 and SOD levels was measured for all studied groups. Results showed that there were no significant variances in age and gestational age distribution between all studied groups. Furthermore, result showed that the serum level o
... Show MoreThe presented investigation, here, was carried out to understand the status of the blood parameters, before and after deworming of Toxocara infection in dogs. For performing the study, 15 pet dogs were recruited from some residential areas in Al-Diwaniyah Province, Iraq. These dogs were exposed to fecal-microscopic based detection of Toxocara eggs and hematological based evaluation of white blood cell (WBC), red blood cell (RBC), and differential counts before and 10 days after treatment with tetramisole. The helminth eggs in the feces of dogs were detected by the flotation method. In case of egg detection, deworming was carried out with tetramisole. The results revealed that the egg number was significantly (p˂0.05) decreased
... Show MoreThe current work concerns preparing cobalt manganese ferrite (Co0.2Mn0.8Fe2O4) and decorating it with polyaniline (PAni) for supercapacitor applications. The X-ray diffraction findings (XRD) manifested a broad peak of PAni and a cubic structure of cobalt manganese ferrite with crystal sizes between 21 nm. The pictures were taken with a field emission scanning electron microscope (FE-SEM), which evidenced that the PAni has nanofibers (NFs) structures, grain size 33 – 55 nm, according to the method of preparation, where the hydrothermal method was used. The magnetic measurements (VSM) that were conducted at room temperature showed that the samples had definite magnetic properties. Additionally, it was noted that the saturation magnetizatio
... Show MoreDiabetes mellitus (DM) is a chronic metabolic disease that is considered a major worldwide healthcare problem. Multiple studies have revealed that people with DM are more likely to acquire oral problems, such as periodontal diseases, because the oral microbiota plays a major role in oral health and may affect the saliva composition. This study aimed to characterize the oral microbiota of a sample of DM patients and its association with some demographic factors, such as smoking habits and gender. A total of 91 specimens, including 51 DM patients and 40 apparently healthy individuals, were enrolled in this study, which was carried out from November 2021 to February 2022. Whole saliva was collected in a sterile tube, and oral swabs
... Show More