Functional dyspepsia is one of the most common gastrointestinal symptoms and attributed to various causes including Helicobacter pylori infection. AIM OF THE STUDY: To correlate Helicobacter pylori infection to functional dyspepsia and to identify the possible risk factors for this infection. PATIENTS AND METHODS: Fifty patients who were referred to the endoscopy unit for dyspepsia symptoms, secondary gastric causes of dyspepsia were excluded during endoscopy, gastric biopsies were taken for histopathological study and for bedside urease test for detection of Helicobacter pylori infection. RESULTS: 62% of non-ulcer dyspeptic patients were infected with Helicobacter pylori, 74.2% of the patients were above 30 years old, female gender patients were more than male patients ( 61.3% versus 38.7%).Using two standard methods of diagnosis of Helicobacter pylori infection, 31 patients had positive histopathology and urease test, 9 of them were positive for helicobacter pylori infection with single method (6 by histopathology and 3 by urease).Histopathology test has sensitivity 88% and specificity 76% in respect to rapid urease test for detection of Helicobacter pylori infection. CONCLUSION: The incidence of helicobacter pylori infection in patients with functional dyspepsia doesn’t differ from what reported in general population in our locality which may argue the role of helicobacter pylori infection in non-ulcer dyspepsia. Female gender and age >30 years were the common risk factors for the infection. Smoking and alcohol consumption were not associated with increased risk of infection.
A batch and flow injection (FI) spectrophotometric methods are described for the determination of barbituric acid in aqueous and urine samples. The method is based on the oxidative coupling reaction of barbituric acid with 4-aminoantipyrine and potassium iodate to form purple water soluble stable product at λ 510 nm. Good linearity for both methods was obtained ranging from 2 to 60 μg mL−1, 5–100 μg mL−1 for batch and FI techniques, respectively. The limit of detection (signal/noise = 3) of 0.45 μg mL−1 for batch method and 0.48 μg mL−1 for FI analysis was obtained. The proposed methods were applied successfully for the determination of barbituric acid in tap water, river water, and urine samples with good recoveries of 99.92
... Show More
(13)
(5)
(24)
(21)
(8)
(8)
The ability of four local fungal isolates for extracellular laccase production has been tested with five grams 1:1(w/v) humidified sawdust as substrate in mineral salt medium. After 21 day of incubation at 25±1 ? C and using one mycelial plug (5mm), higher level of laccase activity (0.15U/ml) and specific activity (15U/mg) were observed by Pleurotus ostreatus in comparison with other fungal isolates. The results of optimum conditions for laccase production from selected isolate showed that, the maximum laccase activity (0.55U/ml) and specific activity (55U/mg) were obtained at moisture ratio 1:3 (w/v), using 3 mycelial plugs (5 mm), after 15 days incubation period at 25±1 ? C. The results of phenol degradation by crud laccase revealed th
... Show More
(2)
(2)
(2)
Each Intensity Modulated Radiation Therapy (IMRT) plan needs to be tested and verified before any treatment to check its quality. Octavius 4D-1500 phantom detector is a modern and qualified device for quality assurance procedure. This study aims to compare the common dosimetric criteria 3%/3 mm with 2%/2 mm for H&N plans for the IMRT technique. Twenty-five patients with head and neck (H&N) tumor were with 6MV x-ray photon beam using Monaco 5.1 treatment planning software and exported to Elekta synergy linear accelerator then tested for pretreatment verification study using Octavius 4D-1500 phantom detector. The difference between planned and measured dose were assessed by using local and global gamma index (GI) analysis method at
... Show More
(3)
(23)
(21)
(23)
(22)
(53)
(11)
The Na-alginate bead is commonly used in biotechnology fields such as adsorption due to ion exchange between Ca and Na with elements. Scanning electron microscopy (SEM-EDX) has proven to be a comparative method in the detections of these adsorbed elements, but the un-flat forming area of beads that can introduce impossible of the detection of element adsorbed. In contrast, X-ray fluorescence (XRF) documents analysis of elements, direct examination, which may analysis the adsorbents of elements. Here, this Study evaluated the possibility by using XRF for the direct analysis for examples of Cd and Ag in a bench stand. This Study compared this to commonly use
... Show More
(6)
(4)