Thermal properties of soils are important in buried structures contact problems. Although laboratory is distinctly advantageous in measuring the thermal conductivity of soil under ideal condition, given the ability to simulate relatively large-scale in place of soil bed, the field thermal conductivity of soil is not yet commonly used in many types of research. The use of only a laboratory experiment to estimate thermal conductivity may be the key reason for overestimation or underestimation it. In this paper, an intensive site investigation including field thermal conductivity tests for six different subsoil strata were performed using a thermal probe method (TLS-100) to systematically understanding the effects of field dry density, water content and soil type. Results were obtained from the alluvial plain lands in the middle part of Iraq, in an attempt to find a correlation between different soil characteristics and the thermal conductivity. It is shown that clayey soil generally had lower thermal conductivity than sandy soil. Thermal conductivity can potentially be affected by the proposed soil low or high plasticity. It is evident that in general, the measured field thermal conductivity value for the lean (low plasticity) silty clay increases with an increase in depth due to the increase of the degree of saturation; however, decreases with an increase in depth for the fat (high plasticity) silty clay. The field water content of the soil in the study obtained here increases so does the thermal conductivity of the soil for most the sites. Further investigations are required, to understand the effects of other environmental conditions with the seasons. This is especially helpful to the future of geotechnical engineering when designing geothermal systems. © 2021 Elsevier Ltd. All rights reserved.
This study detects the presence of the most important steroidal sapogenin “Tigogenin†in the leaves of Yucca aloifolia widely cultivated in Iraq. The absence of any study concerning the Tigogenin content of this medicinal plant in Iraq, and the industrial importance of Tigogenin depending on its role as a precursor in the synthesis of some steroidal drugs, acquired this study its value. This study concerned with extraction, identification, isolation, and purification of Tigogenin from the leaves of Yucca aloifolia. Extraction of this compound was carried out using two methods. Identification of this compound was done using thin layer chromatography (TLC) where different solvent systems had been tried. Liberm
... Show MoreThe study aimed to show the concept and importance of accounting Conservatism, Persistence and volatility of earnings of companies listed in the Iraqi market for securities have been selected 35 companies for the period between 2013 to 2107 used the scale of book value to market value to measure the Conservatism while the current profit regression model was used to measure future profits Eviews 9 was used for the purpose of testing the two hypotheses. The results of the study found that there is a statistically significant relationship between accounting Conservatism and Persistence of earnings. The relationship is inverse with no statistically significant relationship between Conservatism and earnings volatility.
Background: In recent years, the prevalence of obesity has climbed sharply. Still, only a few safe and effective medications are approved as weight-loss drugs. Objective: This study aims to assess the knowledge and practice of community pharmacists in Iraq regarding the use of Liraglutide and Semaglutide as weight-loss medications. Method: A cross-sectional survey was implemented using a validated questionnaire and a convenient sample of Iraqi community pharmacists from different governorates. The questionnaire was created after conducting a literature review of the most important articles about liraglutide and semaglutide. The questionnaire consists of three sections. The first part was used to collect demographic information. The
... Show MoreIn this study, six square reinforced concrete flat plates with dimensions of (1500×1500×100) mm were tested under a concentrated load applied on a column located at the center of the slabs. One of these slabs was the control specimen, whereas, in the others, steel angles (steel collars) were used, fixed at the connection region between the slab and the column to investigate the effect of the presence of these collars on punching shear strength. Five thicknesses were used (4, 5, 6, 8, 10mm) with constant legs of angles (75×75) mm of the steel collars to investigate the effects on the punching shear resistance with respect to the control slab. The results of the experimental study show that the punching shear resistance increased b
... Show MorePatients are very concerned about the lengthy nature of orthodontic treatment. It is necessary to find a non-invasive way to quicken physiologic tooth movement. This study's objective was to assess the effectiveness of low-intensity laser therapy in shortening the time and discomfort of orthodontic treatment. Experimental work: Using a split-mouth study to compare tooth movement with conventional treatment and laser-accelerated orthodontic tooth movement. A patient presenting with a class II division I malocclusion characterized by the misalignment of the upper and lower teeth as classified by Angle’s molar classification system was indicated to undergo fixed orthodontic appliance orthodontic treatment. The treatment plan involved bila
... Show MoreIn the present work, poly methyl methacrylate (PMMA) doped with Rhodamine 6G was prepared. The spectral properties (absorption and fluorescence) of the films were studied at different concentrations (1x10-5, 2x10-5, 5x10-5, 7x10-5, and 1x10-4mol/l). The investigated samples were made in the form of thin films. This was achieved by dissolving a certain weight of PMMA in a fixed volume of chloroform, composite films was with thickness (25.8μm) at room temperature. The achieved results were pointed out that absorption and fluorescence spectra have taken a wide spectral rang so when increased the concentratio
... Show MoreWe wanted to find out how selenium (Se) affects broiler chicken performance, meat physicochemical properties, and selenium deposition in the tissues of broilers. Each of the 96 experimental pens had 30 chickens and included a total of 2,880 one-day-old broilers (Cobb 500 strain). A factorial design of four-by-three (SY + SS) and eight replicates (SY + SS) was used for the 12 experimental treatments, with selenium levels ranging from 0.15 to 0.60 ppm and organic (SY) or inorganic (SS) sources of selenium and their relationship (SY + SS). There were no differences in performance (P > 0.05) across Se levels or sources. 106 g/day of ADFI, 63 g/day of ADG, and 1.6844 kg/kg of FCR were found to be the averaging values for these three parameters:
... Show More