Periodontitis is one of the most prevalent bacterial diseases affecting man with up to 90% of the global population affected. Its severe form can lead to the tooth loss in 10-15% of the population worldwide. The disease is caused by a dysbiosis of the local microbiota and one organism that contributes to this alteration in the bacterial population is Prophyromonas gingivalis. This organism possesses a range of virulence factors that appear to contribute to its growth and survival at a periodontal site amongst which is its ability to invade oral epithelial cells. Such an invasion strategy provides a means of evasion of host defence mechanisms, persistence at a site and the opportunity for dissemination to other sites in the mouth. However, previous studies have demonstrated that invasion of the mammalian cells in a population by P. gingivalis is heterogenous, with some cells becoming heavily invaded while others harbour no or only a few bacteria. An understanding of this heterogeneity may throw light on the mechanisms involved and we hypothesised that the phase of the host cell cycle may explain this phenomenon. In an attempt to study the factors influencing P. gingivalis invasion and the cell response to that invasion, a standard antibiotic protection assay was employed and an oral keratinocyte cell line, H357. The results showed that P. gingivalis NCTC 11834 invasion was significantly increased with increasing time of exposure to the cells and the cell density. This may reflect an increased host cell surface area available for bacterial attachment. No effect on invasion of P. gingivalis invasion was observed by the bacterial growth phase, H357 cell passage number or whether cells were pre-incubated with P. gingivalis lipopolysaccharide. Epithelial cells did, however, respond to the presence of P. gingivalis in a number of ways. For example, the mRNA expression of endothelin-1 and urokinase receptor were upregulated with increasing P. gingivalis infection time, suggesting that these proteins could act as inflammatory mediators and possibly as useful markers of the severity of periodontal disease or in the diagnosis and treatment of periodontitis. iii Secondly, in an attempt to investigate the reason for the observed heterogeneous P. gingivalis invasion of H357 cell populations, the effect of cell cycle phase on P. gingivalis invasion was investigated. H357 cells were synchronized by serum starvation. On re-introduction of serum, characterisation of cell cycle phase distribution was performed by flow cytometry following staining with propidium idodide (PI) or by immunofluorescence using bromodeoxyuridine (BrdU), which specifically identifies cells in S-phase. The effect of cell cycle phases on P. gingivalis invasion was measured using the antibiotic protection assay, immunofluorescence and flow cytometry and these were correlated with gene and surface expression of the urokinase receptor and the α5-integrin subunit, which is thought to mediate P. gingivalis invasion. Results showed that the percentage invasion was enhanced with increasing serum re-introduction time, and positively correlated with the number of cells in S-phase. In addition, flow cytometry data showed that the highest association of fluorescent P. gingivalis was with PI positive S-phase cells. Moreover, BrdU positive S-phase cells were 3 times more likely to be invaded and contained 10 times more P. gingivalis than cells in other phases. Also, α5-integrin was more highly expressed in cells in S-phase than other phases, which could explain the mechanism underlying this enhanced invasion. Data presented here have suggested that P. gingivalis targeting of cells in S- phase could, in vivo, allow preferential invasion of the junctional epithelial cells which turns over rapidly. The data presented in this thesis suggest that P. gingivalis invasion is greatly dependent on several factors attributed to the host, the bacteria itself, and to the environment which the bacteria reside in. The invasion occurs within a population of host cells in a heterogeneous fashion, and is dependent on the cell cycle phase, specifically S-phase. This novel finding, in addition to the previously reported mechanisms of P. gingivalis invasion, increases our understanding of this virulence trait and suggests that such a strategy is a highly organised process which the bacteria can follow to ensure its survival within the host. Furthermore, knowledge of these mechanisms could provide novel approaches to treatment of periodontal diseases.
Spin coating technique used to prepare ZnPc, CdS and ZnPc/CdS blend thin films, these films annealed at 423K for 1h, 2h and 3h. Optical behavior of these films were examined using UV-Vis. and PL. The absorption spectrum of ZnPc shows a decreasing in absorption with the increase of annealing time while CdS spectrum give a clearly absorption peak at~510 nm. Energy gap of ZnPc increases from 1.41 to 1.52 eV by increasing the annealing time. Eg of CdS decrease by increasing annealing time, from 2.3 eV to 2.2 eV. The intensities of the peaks obtained from PL spectra were strongly dependent on annealing time and confirmed the results obtained from UV-Vis. D.C. conductivity measurement showed that all the thin films have two differen
... Show MoreOriental wasps are scavengers, and they have also represented an enormous issue for beekeepers, they destroy beehives and reduce the flight of bees. In addition, the sting of hornets may cause medical problems, which differ according to the response of the individuals, including severe sensitivity, swelling, and slight pain. This study provides the first molecular phylogeny of the oriental wasp
The analysis of rigid pavements is a complex mission for many reasons. First, the loading conditions include the repetition of parts of the applied loads (cyclic loads), which produce fatigue in the pavement materials. Additionally, the climatic conditions reveal an important role in the performance of the pavement since the expansion or contraction induced by temperature differences may significantly change the supporting conditions of the pavement. There is an extra difficulty because the pavement structure is made of completely different materials, such as concrete, steel, and soil, with problems related to their interfaces like contact or friction. Because of the problem's difficulty, the finite element simulation is
... Show MoreTiO2 thin films were deposited by reactive d.c magnetron sputtering method on a glass substrate with various ratio of gas flow (Oxygen /Argon) (50/50, 100/50 and 150/50) at substrate temperature 573K. It can be observe that the optical energy gap of TiO2 thin films dependent on the ratio of gas flow (oxygen/argon), it varies between (3.45eV-3.57eV) also it is seen that the optical constants (α, n, K, εr and εi ) has been varied with the change of the ratio of gas flow (Oxygen /Argon).
In the literature, several correlations have been proposed for hold-up prediction in rotating disk contactor. However,
these correlations fail to predict hold-up over wide range of conditions. Based on a databank of around 611
measurements collected from the open literature, a correlation for hold up was derived using Artificial Neiral Network
(ANN) modeling. The dispersed phase hold up was found to be a function of six parameters: N, vc , vd , Dr , c d m / m ,
s . Statistical analysis showed that the proposed correlation has an Average Absolute Relative Error (AARE) of 6.52%
and Standard Deviation (SD) 9.21%. A comparison with selected correlations in the literature showed that the
developed ANN correlation noticeably
Natural frequency under initial stresses for simply supported cross-ply composite laminated plates (E glass- fiber) are obtained using Refind theory (RPT). This theory accounts for parabolic distribution of the transverse shear strain through the plate thickness and satisfies the zero traction boundary conditions on the surfaces of the plate without using shear correction factors. The governing equations for Eigen value problem under initial stress are derived using Hamilton’s principle and solved using Navier solution for simply supported cross-ply symmetric and antisymmetric laminated plates. The effect of many design factors such as modulus ratio, thickness ratio and number of laminates on the Natural frequency and buckling stresses
... Show MoreZigbee, which has the standard IEEE 802.15.4. It is advisable method to build wireless personal area network (WPAN) which demands a low power consumption that can be produced by Zigbee technique. Our paper gives measuring efficiency of Zigbee involving the Physical Layer (PL) and Media Access Control (MAC) sub-layer , which allow a simple interaction between the sensors. We model and simulate two different scenarios, in the first one, we tested the topological characteristics and performance of the IEEE802.15.4 standard in terms of throughput, node to node delay and figure of routers for three network layouts (Star, Mesh and Cluster Tree) using OPNET simulator. The second scenario investigates the self-healing feature on a mesh
... Show More