One of the important objectives of the varistor is for a sustainable environment and reduce the pollution resulting from the frequent damage of the electrical devices and power station waste. In present work, the influence of Al2O3 additives on the non –linear electrical features of SnO2 varistors, has been investigated, where SnO2 ceramic powder doped with Al2O3 in three rates (0.005, 0.01, and 0.05), the XRD test improved that SnO2 is the primary phase, while CoCr2O4, and Al2O3 represent the secondary phases. The electrical tests of all prepared samples confirmed that the increasing of Al2O3 rates and sintering temperature improves and increase the electrical features, where the best results obtained at Al2O3 (0.05) and 1000℃, the non-linear coefficient (49), energy absorption capability (3890Joul), and breakdown voltage (4040Volt), while the leakage current passes through the varistor decreased to the minimum value (41μA).
The present work covers the analytical design process of three dimensional (3-D) hip joint prosthesis with numerical fatigue stress analysis. The analytical generation equations describing the different stem constructive parts (ball, neck, tour, cone, lower ball) have been presented to reform the stem model in a mathematical feature. The generated surface has been introduced to FE solver (Ansys version 11) in order to simulate the induced dynamic stresses and investigate the effect of every design parameter (ball radius, angle of neck, radius of neck, neck ratio, main tour radius, and outer tour radius) on the max. equivalent stresses for hip prosthesis made from titanium alloy. The dynamic loading case has been studied to a stumbling ca
... Show MoreIn this study, flow-based routing model is investigated. The aim of this study is to increase scalability of flow control, routing and network resources solutions, as well as to improve Quality of Service and performance of the whole system. A method of hierarchical routing is proposed. The goal coordination method alsoused in this paper. Two routing models (model with quadratic objective function and model with traffic engineering) were fully analyzed. The basic functions of the hierarchical routing model levels based on goal coordination method were addressed Both models’ convergence is also explained. The dependence of the coordination iterations number on the packet flow rates for both models is graphically shown. The results shows
... Show MoreThe research is concerned with the problems of knowledge purification of kindergarten children by verifying its aims, identifying of knowledge purification among the first level of kindergarten children and the second level of kindergarten children, and the differences between the males and females in the variable of knowledge purification. The research community included the children in the state and private kindergartens in Baghdad governorate, on its two sides, Karkh and Rusafa, for the six districts for the academic year 2022-2023. After making the knowledge purification test according to the scientific steps of test constructions, the test has been presented to a group of experts specialized in the field of kindergarten to ascertain
... Show MoreThe objective behind this work was to find out the bacteriological profile of post burn infections in wound. The study was carried out from December 2010 to February 2011 at the Burns Unit of Al –Kindy Hospital and Al-Yarmook Hospital in Baghdad. Sixty burn patients have been investigated for bacterial profile of burn wound infections. Specimens were collected in the form of wound swabs. The organisms were isolated and identified by standard microbiological methods. Antimicrobial susceptibility test has been done by ATB-PSE5 kit(BioMereiux). Pseudomonas aeruginosa 35(58.3 %) was found to be the most common isolate followed by Klebsiella pneumonae 10(16.6%), Staphylococcus aureus 7(10%). ,E.coli 3(5%), Proteus merabilis 1(1.6 %), others 2
... Show MoreEssentilas of Atmospheric Sciences - ISBNiraq.org
Identification by biological features gets tremendous importance with the increasing of security systems in society. Various types of biometrics like face, finger, iris, retina, voice, palm print, ear and hand geometry, in all these characteristics, iris recognition gaining attention because iris of every person is unique, it never changes during human lifetime and highly protected against damage. This unique feature shows that iris can be good security measure. Iris recognition system listed as a high confidence biometric identification system; mostly it is divide into four steps: Acquisition, localization, segmentation and normalization. This work will review various Iris Recognition systems used by different researchers for each recognit
... Show MoreThe diagnoses system of varicose disease has a good level of performance due to the complexity and uniqueness in patterns of vein of the leg. In addition, the patterns of vein are internal of the body, and its features are hard to duplicate, this reason make this method not easy to fake, and thus make it contains of a good features for varicose disease diagnoses. The proposed system used more than one type of algorithms to produce diagnoses system of varicose disease with high accuracy, in addition, this multi-algorithm technique based on veins as a factor to recognize varicose infection. The obtained results indicate that the design of varicose diagnoses system by applying multi- algorithms (Naïve Bayes and Back-Propagation) produced new
... Show MoreFor the generality of fuzzy ideals in TM-algebra, a cubic ideal in this algebra has been studied, such as cubic ideals and cubic T-ideals. Some properties of these ideals are investigated. Also, we show that the cubic T-ideal is a cubic ideal, but the converse is not generally valid. In addition, a cubic sub-algebra is defined, and new relations between the level subset and a cubic sub-algebra are discussed. After that, cubic ideals and cubic T-ideals under homomorphism are studied, and the image (pre-image) of cubic T-ideals is discussed. Finally, the Cartesian product of cubic ideals in Cartesian product TM-algebras is given. We proved that the product of two cubic ideals of the Cartesian product of two TM-algebras is also a cubic idea
... Show More