Introduction: Nitrofurantoin (NFT) is abroad spectrum bactericidal antibiotic. The bioavailability of NFT is affected by many factors. Samafurantin® tablets containing 50 mg NFT were manufactured by Samarra drug industry. Urinary excretion studies were employed since; the urinary tract is the main site of NFT action and excretion. Objective: The objective of the study was to investigate the effect of Uricol® and food on secondary pharmacokinetic parameters of Samafurantin® tablets with different doses by applying urinary data. Methods: Twelve healthy male volunteers participated in this study. Urine samples were collected from each volunteer after overnight fasting at a specified time intervals which considered as a blank sample for measuring urine pH of urine. After that, volunteers were randomly divided into two groups (G1 and G2) each of six. Group 1 was administered 100 mg of NFT (Two tablets of 50 mg Samafurantin®) while, G2 was administered 200 mg of NFT (Four tablets of 50 mg Samafurantin®) as a single oral dose. Both groups administered the dose on an empty stomach (fasting), along with one Uricol® of 5 g sachet on fasting, and on full stomach after eating a standard breakfast after 1-week washout period between each experiment and another. For each experiment, urine samples were collected from each volunteer from 0.25 to 7 h post dosing. In addition, the volume of each void urine sample was measured. Results: Both groups (G1 and G2) showed only slight differences in the pH of urine after administration of Samafurantin® as compared with that of the blank. While, the pH of urine for both groups was higher after administration of Samafurantin® tablets along with Uricol® 5 g. In both groups, each of Uricol® and food exhibited no significant differences (P < 0.05) in secondary pharmacokinetic parameters of NFT; the rate constant of elimination (Kel) and absorption (Ka) and consequently their half-life (t0.5 el and t0.5 abs) as long as the drug followed first-order kinetics. While significant differences (P < 0.05) were observed for maximum excretion rate (ExRmax), cumulative amount excreted in urine (CAe) and CAe as percentage of the dose. This could be attributed to the pH-change of urine by Uricol® which alkalinized the urinary and kidney tract or delaying gastric emptying by food. Same observations were attained when comparing G1 with G2 after administration of NFT on fasting. Conclusions: Administration of Samafurantin® tablets at higher doses, along with Uricol® or with food increases secondary pharmacokinetic parameters related to the rate and extent of absorption and elimination without significant changes in their corresponding rate constants and half-lives. © 2018 Drug Invention Today.
Multiple Sclerosis (MS), is a common autoimmune disease that affects the central nervous system. Currently, there is no cure for MS, and most treatments involve the use of immunosuppressive drugs that can have adverse effects or increased toxicity. Cannabis, commonly known as marijuana, is a product of the Cannabis sativa, and for several centuries has been used as an alternative medicine in many cultures. Cannabis sativa produces over 421 chemical compounds, including about 80 terpenophenols named phytocannabinoids, and include both psychotropic THC and non-psychoactive CBD. In the currently study, we show that a combination therapy using THC and CBD results in amelioration of EAE, a
A chemometric method, partial least squares regression (PLS) was applied for the simultaneous determination of piroxicam (PIR), naproxen (NAP), diclofenac sodium (DIC), and mefenamic acid (MEF) in synthetic mixtures and commercial formulations. The proposed method is based on the use of spectrophotometric data coupled with PLS multivariate calibration. The Spectra of drugs were recorded at concentrations in the linear range of 1.0 - 10 μg mL-1 for NAP and from 1.0 - 20 μg mL-1 for PIR, DIC, and MEF. 34 sets of mixtures were used for calibration and 10 sets of mixtures were used for validation in the wavelength range of 200 to 400 nm with the wavelength interval λ = 1 nm in methanol. This method has been used successfully to quant
... Show MoreA new set of metal complexes by the general formula [M(P)2(H2O)2]Cl2 has been prepared through the interaction of the new Ligand [N1, N4-bis(4-methoxyphenyl)succinamide] (P) derived from succinyl chloride with p-anisidine with the transition metal ions [Cu(II), Mn(II), Cd(II), Co(II) and Ni(II)]. Compounds diagnosed by TGA, 1 H, 13CNMR and Mass spectra (for (P)), Fourier-transform infrared and Electronic spectrum, Magnetic measurement, molar conduct, (%M, %C, %H, %N). These measurements indicate that (P) is associated with the metal ion in a bi-dentate fashion by nitrogen atoms (the amide group), and the octahedral composition of these complexes is suggested. Staphylococcus Aureus (+) and Escherichia Coli (–) were studied for the antibact
... Show MoreBACKGROUND: Sacral nerve stimulation (SNS) approved for use in North America since 1997 despite the fact that the concept of using SNS to treat patients with voiding dysfunction discussed first almost 50 years ago. AIM: The objectives of the study were to assess the effectiveness of SNS the short and long term for patients with overactive bladder (OAB) dysfunction and its relation to age, gender, and causes. PATIENTS AND METHODS: This is a clinical prospective study that involved 50 cases (32 females and 18 males) with OAB. It was carried out at Ibn Sina Hospital, and the neurosciences hospital in Baghdad/Iraq from April 2015 to April 2018. All the patients were assessed preoperatively and certain inclusion criteria were
... Show MoreThis research is devoted to study the effect of different in weight percentage of Sio2 particles and glass fibers (5, 10, 15, 20) wt. % on the wear rate epoxy resin. The results show that the value of hardness increase with the increase for the weight percentage of reinforcing particles and fibers, while the wear rate decrease with the increase the load level of the reinforcing particles and fibers . The largest value of the hardness, and the lowest value of the wear rate for epoxy reinforced with 20% of SiO2, the wear rate increase in general with increasing the applied load.