The high bounce activity according to the fosbery way is regarded as of the difficult sports concerning its way of training and perfection due to hard technique of its performance on one hand and because it depends on the player’s ability to overcome body weight resistance against the gravity. In addition to the strong ability to control the body posture when leaving the land and flying over the barrier. This activity needs to high plosion power at the moment of bouncing and this plosion depends on the period of bouncing, so the two researchers aimed to use a mechanical bouncing platform and an electronic one through several training by one foot and both feet in different directions and positions in order to reduce the time of bouncing and increase the plosion power. So the study aims to identify the influence of the jumping trainings on a bouncing platform to improve the time of bouncing and the plosion power of the players under the age of 18. The experimental approach has been used to design the group of trainings pertaining and post training. The sample of the study is four players that have been selected from Al Hilla club for high bouncing. All of them are under the age of 18 and they represent the society for 100%. The post evaluation for the bouncing time and the plosion power by using the platform as it is for evaluation and training. After that, the training has started on the platform by the sample in 15/3/2021 to 9/5/2021 two times a week. The training has been accomplished on the designed platform at the main part of training lesson directly after warming up and for twenty minutes. The training was performed depending on the principle of gradiance and ripple among the trainings, units and the weeks of training period. The replacement of the muscular groups have been used between one training and another by using the high periodic training and the two researchers have not interrupted in the rest of the parts of the training . After the training finished. The post tests have been perrformed and the results have been calculated statistically by using SPSS and the study reached to that the training on the bouncing back platform reduced the time of bouncing and increased the plosion power for the high bouncing players under the age of 18 and this is a positive index to reach better height over the barrier. So it is recommended to perform the high bouncing training on a bouncing platform in order to improve the time of bouncing and the power of plosion for the high bouncing players under the age of 18 .
Free cement refractory concrete is a type of refractory concrete with replacing alumina cement by bonding materials such as white kaolin, red kaolin and fumed silica. The free cement refractory concrete used in many applications like Petrochemicals, iron furnaces and cement production industries. The research clarifies the effect of steel fibers with two types crimped steel fibers and hooked steel
fibers with percentages 0.5%, 1% and 1.5% by volume from weight of bauxite aggregates. The additions of steel fibers with two types gave good properties in high temperatures where the specimens keep the dimension without failure and the properties made the best. the percentage of increasing for thermal conductivity was 44% for 1.5% crimped
(2)
Sheets of Epoxy (EP) resin with addition of TiO2 of grain size (1.5μm, and 50nm) and weight percentage (1%, 3%, and 5%) were prepared. Discs of 20mm diameter and 3mm thickness were cut for dielectric measurements. Dielectric properties (dielectric constant, dispassion factor and electrical conductivity) over the frequency range 102 -106 Hz were measured.
Comparison was made between the effect of micro and nano particles of TiO2 on the dielectric properties of EP composites with different weight percentage. Epoxy composites with micro sized particles of TiO2 were observed to have the better values of dielectric properties.
This study is concerned with the effect of Deep Cryogenic Treatment (DCT) at liquid nitrogen temperature (-196 o C) on the mechanical properties and performance of low carbon steel (A858). The tests specimens were divided in to two groups, the first group was subjected to the conventional heat treatment of normalizing, and the second group was also normalized then subjected to (DCT). The results have shown that after (DCT), the Hardness, Tensile properties and the impact energy absorbed were all slightly increased. However the fatigue test showed some positive improvement in fatigue limit by 20(N/mm2 ), and the volume wear rates at different loads were significantly decreased after (DCT). The changes in microstructure due to (DCT) were c
... Show More
(1)
Two grades of paving asphalt with penetration of 46 and 65 are studied for determining changes in their physical and chemical properties caused by ageing.
The ageing process has been conducted on two petroleum paving asphalt cement using thin film oven test at 150, 163 and 175 C, and ageing time 5, 10,15, 20, 25 and 30 hours. The effect of ageing time and temperature on penetration, kinematic viscosity, softening point, solubility in trichloroethylene, heat loss and changes in chemical composition are investigated. The results of thin film oven test process indicte that the asphaltenes concentration of all aged asphalt increases with increasing ageing time, while the opposite was observed for polar-aromatic and naphthene-aromatic. The
(5)
Despite widespread agreement on the beneficial nature of hydrated lime (HL) addition to asphalt concrete mixes, understanding of the effect of HL particle size is still limited. Previous investigations have focused mainly on two different size comparisons, and so certain guidance for a practical application cannot yet be produced. This study investigates three distinct sizes of HL, in the range of regular, nano, and sub-nano scales, for their effects on the properties of modified asphalt concretes. Five different percentages of HL as a partial replacement of ordinary limestone filler in asphalt concrete mixes were studied for wearing course application purposes. Experimental tests were conducted to evaluate the mechanical properties
... Show More
(18)
(16)
إنّ التّأمّل في الدّراسات الأدبيّة النّقديّة الحديثة الّتي تنظر إلى النّصّ أنّه لوحة تتشكّل من مجموعة تداخلات نصّيّة سابقة للنصّ المُنتج أو مُعاصرة له، تدفع القارئ إلى الغوص في أعماق النّصوص وتحليلها والكشف عن الآليّات والإجراءات الّتي اعتمدت في إنتاجه، وإظهار الجماليّات الفنّيّة التي شكلت في مُجملها كائنا حيّا يُعبّر عن حالات إنسانيّة مُستمرة الحدوث رغم تقادم الأزمان.
فالبحث هذا يعمد
... Show MoreThe research aims to identify the most important difficulties facing the scientific research in the technical university in the financial, organizational and administrative according to the quality standards according to the paragraphs studied in the questionnaire questionnaire prepared for this purpose, including the research community on the Central Technical University, which includes several technical colleges and technical institutes were selected A sample of the researchers in the Institute of Technical Management where the number of training was 78 teachers took a random sample of researchers amounted to 40% of the questionnaire, and after the collection and classification of data were used statistical means, including the mean ar
... Show More