ABSTRACTObjective: The objective of this study is to develop a controlled release matrix tablet of candesartan cilexetil to reduce the frequency of administration,enhance bioavailability and improve patient compliance; a once daily sustained release formulation of candesartan cilexetil is desirable.Methods: The prepared tablets from F1 to F24 were evaluated with different evaluation parameters like weight variation, drug content, friability,hardness, thickness and swelling ability. In vitro release for all formulas were studied depends on the type and amount of each polymer, i.e. (16 mg,32 mg and 48 mg) respectively beside to the combination effect of polymers on the release of the drug from the tablet.Results: In vitro release show

   SAPO-11 is synthesized from silicoaluminophosphate in the presence of di-n-propylamine as a template. The results show that the sample obtained has good crystallinity, 396m²/g BET surface area, and 0.35 cm³/g pore volume. The hydroisomerization activity of (0.25)Pt (1)Zr (0.5)W/SAPO-11 catalyst was determined using n-decane and base oil. All hydroisomerization experiments of n-decane were achieved at a fixed bed plug flow reactor at a temperature range of 200-275°C and  LHSV 0.5-2h^-1.  The results show that the n-decane conversion increases with increasing temperature and decreasing LHSV, the maximum conversion of 66.7 % was achieved at temperature 275°C and LHSV of 0.5 h^-1

SAPO-11 is synthesized from silicoaluminophosphate in the presence of di-n-propylamine as a template. The results show that the sample obtained has good crystallinity, 396m2/g BET surface area, and 0.35 cm3/g pore volume. The hydroisomerization activity of (0.25)Pt (1)Zr (0.5)W/SAPO-11 catalyst was determined using n-decane and base oil. All hydroisomerization experiments of n-decane were achieved at a fixed bed plug flow reactor at a temperature range of 200-275°C and  LHSV 0.5-2h-1.  The results show that the n-decane conversion increases with increasing temperature and decreasing LHSV, the maximum conversion of 66.7 % was achieved at temperature 275°C and LHSV of 0.5 h-1. Meanwhile, the same catalyst was used to improve base oil spec

Background: one of the complications of rigid bronchoscope is the cardiovascular responses that may carry a dangerous drawback during and after the procedure. Prevention and control of these events will be crucial, especially for the old and cardiovascular debilitated patients.
Objective: The study aims to control and attenuate the unwanted hemodynamic responses to the rigid bronchoscpe using intravenous lidocaim and GTN.
Method: a study was performed on three groups of patients undergone a diagnostic procedure of bronchoscope. Each group consists of 20 patients at the same age and relatively similar pathology. The three groups (group one, two and three) received lidocaine, glyceryltrinitrate and no drug re

The   mechanical    properties   of   fiber-reinforced-polymer   (FRP)

composites are dependent on the type amount, and orientation of fiber that is selected for a particular service. There are many commercially available reinforcement forms to meet the design requirements of the user. The ability of failure in the fiber architecture allows for optimized performance of a product that saves both weight and cost ( 12).

A modem technology is adopted to produce fibers (glass, kevelar,

and carbon) reinforced composite by using unsaturated polyester, where different volume fraction  of these fibers are used  (0, 0.2, 0.4, 0.6, 0.8,  I)

reinfor

A high Tc superconductor with a nominal composition
(Bi1-xPbx)2(Sr1-yBay)2Ca2Cu3O10+δ for (0 £ x £ 0.5) and (0 £ y £ 0.5) was prepared by
a solid state reaction method. The effect of the substitution of Pb for Bi and Ba for Sr and
quenching temperature on the superconductivity has been investigated to obtain the
optimum conditions for the formation and stabilization of the high Tc phase (2223).
The results showed that the optimum sintering temperature for the pure composition is
equal to 875°C and the sintering time is equal to 240h with heating and cooling rate of
60°C/h . Our results indicated that a small amount of (Ba = 0.1) could raise the transition
temperature (Tc), but enhancing Ba to 0.4 has raised

This study was conducted to evaluate the activity of pomegranate (Punica granatum L.) peel powder and Pseudomonas fluorescens against Pythium aphanidermatum the causal agent of cucumber seedlings damping-off. Results showed that augmenting of pomegranate peel powder at 2%, P. fluorescens suspension contain 4×107cfu/ml, and the fungicide Previcure N at 0.5 ml/L to culture media (PDA) were inhibited the pathogen growth by 100, 100 and 72.1% respectively. Results of greenhouse experiment indicated that treatment of cucumber seeds with pomegranate peel powder, reduced pre-emergence damping-off percentage to 3.3% compared with 16.6% disease with P. fluorescens and 96.6% in control treatment (pathogen only). No significant differences were ob

The ground state proton momentum distributions (PMD) and elastic charge form
factors for some odd 1f  2p shell nuclei, such as , , 59 63Co Cu and Cu 65 have been
studied using the Coherent Density Fluctuation Model and formulated by means of
the fluctuation function (weight function) ( ) .
2
f x The fluctuation function has been
connected to the charge density distribution of the nuclei and determined from the
theory and experiment result. The feature of the long-tail behavior at high
momentum region of the PMD has been calculated by both the theoretical and
experimental fluctuation functions. It is found that the inclusion of the quadrupole
form factors ( ) 2 F q C in all nuclei under study, which are de