Background: The bond strength of the root canal sealers to dentin seems to be a very important property for maintaining the integrity and the seal of root canal filling. The aim of this study was to evaluate the shear bond strength of four different obturation systems using push-out test. Materials and methods: Forty straight palatal roots of the maxillary first molars teeth were used in this study, these roots were instrumented using crown down technique and ProTaper system, instrumentation were done with copious irrigation of 2.5% sodium hypochlorite and 17% buffered solution of EDTA was used as final irrigant followed by distilled water, roots were randomly divided into four groups according to the obturation system (ten teeth for each group): Group I: AH26 sealer and lateral condensation technique, Group II: AH26 sealer and single cone obturation technique, Group III: AH26 sealer and thermafil obturation technique and Group IV: RealSeal SE sealer and lateral condensation technique, the roots then stored in moist environment at 37°C for one week The roots were embedded in clear acrylic resin and each root sectioned into three levels apical, middle and cervical. The measurement of each section was taken to prepare the supporting jig for the sections and the punch used in pushout test, the bond strength was measured using computerized universal testing machine each section fixed in the machine so that the load applied from apical to cervical direction at 0.5mm/min. speed and the computer drew curve to show the higher bond force before dislodgment of the filling material. These forces were divided by the surface area to obtain the bond strength in MPa. Results: Statistical analysis was performed and the result showed avery highly significant differences between the four obturation systems at each level and there were non significant differences between all level apical, middle and cervical within each obturation system except a significant difference found between cervical and apical level in single cone obturation system. Conclusion: This study showed that the shear bond strength of AH26 sealer was higher than RealSeal SE sealer when the same obturation technique was used. The shear bond strength was affected by the obturation technique and lateral condensation technique showed higher bond strength than thermafil and single cone obturation technique when the same type of sealer was used and the bond strength was not or little affected by the tooth level
Background: Cataract is a major cause of visual impairment and blindness around the world. This study evaluated the in vitro antioxidant and anti-cataract activities of Cnidoscolus aconitifolius leaves extract and fractions. Antioxidant activities were evaluated by 2,2-diphenyl-1-picrylhydrazyl (DPPH), 2,2-azinobis (3-ethylbenzothiozoline-6-sulfonic acid) (ABTS), total reducing power, and hydrogen peroxide scavenging assays. Anti-cataract potential was evaluated in vitro using goat lenses divided into eight groups of different treatments and incubated in artificial aqueous humor at 37 °C for 72 hours. Glucose-induced opacity in the lenses was observed and biochemical indices quantified (cata
... Show More
(2)
Background: Nickel-titanium (NiTi) archwires have become increasingly popular because of their ability to release constant light forces, which are especially useful during initial alignment and leveling phase. The aim of the present study was to investigate and compare the load–deflection characteristics of four commercially available NiTi archwires. Materials and methods: 200 NiTi 0.014, 0.016, 0.018, 0.016x0.022 and 0.019x0.025-inch nickel–titanium archwires from four different manufacturers (3M, Ortho Technology, Jiscop and Astar) were tested. The load-deflection properties of these archwires were evaluated by a full arch bending test in both palatal and gingival directionsat 37°C temperature using a universal material t
... Show MoreThis study was done to investigate the antibacterial effect of the three types of Lawsonia inermis linn (henna) leaf extracts (water, methanol and chloroform) in different concentrations (40, 80, 120) mg/ml against four strains of bacteria (Staphyllococus aureus, Bacillus subtilis, Pseudomonos aerogenosa and Eschorichia coli) in vitro using ager well diffusion method. Water extract showed the highest antibacterial activity, followed by methanol extract, while the chloroform extract showed the lowest activity. The maximum inhibition zone of water extract was observed against , Pseudomonos aerogenosa (25mm) in the concentration (120) mg/ml, while the minimum zone of inhibition (9mm) was in Bacillus subtilis in the same concent
... Show MoreLeishmania are protozoan parasites belonging to the family Trypanosomatidae that cause high morbidity and mortality levels with a wide spectrum of clinical syndrome. This study aimed to investigate the effect of liposomal amphotericine B (AmBisome) drug on promastigote and axenic amastigote stages of Leishmania donovani isolate (MHOM/IQ/2005/MRU15)in comparison with pentostam SbV drug. Different concentrations of AmBisome and SbV drugs were investigated against Leishmania donovani promastigote and axenic amastigote. The ICR50R values of SbV and AmBisome drugs on promastigote were10.12 mg/ml and 2.21μg/ml, respectively, while they were 0.77μg/ml for axenic amastigote for both drugs. The present study concluded that axenic amastigote was
... Show MoreLeishmania are protozoan parasites belonging to the family Trypanosomatidae that cause high morbidity and mortality levels with a wide spectrum of clinical syndrome. This study aimed to investigate the effect of liposomal amphotericin B (AmBisome) drug on promastigote and axenic amastigote stages of Leishmania tropica. From the 20 isolates of cutaneous leishmaniasis collected from patients attended to the AL-Karama Teaching Hospital in Baghdad during the period from October 2013 until February 2014, only three isolates successfully transformed to motile promastigote stage in the culture media. The most active one is included in this study. Different concentrations of liposomal amphotericin B (AmBisome) and pentostam Sb (V) drugs were inv
... Show MoreThe research was conducted to study the effect of adding different concentrations of AgNo3 Nanoparticles (0,0.5,1.0,1.5,2.0) mg/ l in the production of some secondary metabolic compounds(Quercetin, Luetolin and Apigenin) of plant Dodonaea viscosa L. Quantitative and qualitative analysis of secondary metabolites were estimated by using( HPLC ). The explants from leaves were culture on MS media supplemented with 2mg/l of 2,4-D, 0.5mg/l of NAA and 0.5 mg/l of BA for callus induction. Adding AgNo3 Nanoparticles (2 mg/l) cause in significant increase of Quercetin and Luetolin production, while adding AgNo3 Nanoparticles (0.5mg/l) led to significant increase of Apigenin in callus extract.
The aim of the research was designing a nutritional program with amino acids well as designing exercises for muscular strength training for youth female badminton players. In addition to that the researcher aimed at identifying the effect of amino acid accompanied with muscular training on some physiological indicators in youth female badminton players. The researcher used the experimental method. The subjects were (7) youth female badminton players from the Armenian badminton club. Many physiological tests were conducted including PWC170 and Vo2Max. The data was collected and treated using proper statistical operations to conclude that amino acid accompanied with muscular ability training have a positive effect on some physiological indica
... Show More
(3)
(2)
In this study, silver nanoparticles (AgNPs) are synthesized using different chemical routes to obtain different sizes and shapes of nanoparticles by colloid chemistry with using stabilizing and reducing agent, which make them interesting for variety of physical applications. The morphology and structure of the synthesized AgNPs were characterized by UV-VIS spectra, Scanning Electron Microscopy (SEM) and Zeta potential to demonstrate that different sizes and shapes can by synthesized by different reductants in the presence of various stabilizing agents.