Abstract Candida albicans is a commensal fungal pathogen that grows in yeast and hyphal forms in the human gut. C. albicans causes mucosal and cutaneous diseases that can result in significant mortality following systematic infections and it also exhibits drug resistance. Zebrafish have been an excellent model to investigate C. albicans infections because of their transparency and the availability of many transgenic lines. However, there is a limitation in using zebrafish as a model because the fish embryos cannot survive at 37°C therefore it is not suitable for studying Candida infections at physiological relevant human body temperature. In this thesis, the normal embryonic development of Arabian killifish (A. dispar) is investigated, revealing that embryogenesis was divided into 32 stages based on diagnostic patterns of development. A. dispar can also found to tolerate a wide range of temperatures and salinities. This suggests that A. dispar could be developed as a novel model to investigate host-pathogen interactions. The tolerance of A. dispar to high temperatures may in part be attributable to brown pigment cells with a highly fluorescent character that may have developed to allow the fish to adapt to live within extreme environmental conditions with strong sunlight and a wide range of temperatures (Chapter 3). In terms of Candida infections, this study examined A. dispar as a model to test C. albicans pathogenicity. The survival of A. dispar embryos following Candida infection showed a dose dependent relationship. We also found that A. dispar can survive longer than zebrafish after infection. Furthermore, C. albicans cells were observed to undergo a transition from yeast to hyphae at 37°C. An investigation of the ability of mutant strains of C. albicans with defects in cell wall mannosylation revealed a significant impact on virulence, host mortality, and the fishes’ immune response. The present study found that although the deletion of O- and N-mannan from the cell wall of C. albicans, affected fungal burden (attenuation), and the survival of the infected embryos per se was significantly decreased in the infections of the mutant strains compared to the WT. This data confirms the importance of the mannosylation state of the cell wall in triggering an immune recognition event (Chapter 4). A. dispar is also shown to be suitable for studying the effectiveness of 3 | P a g e antifungals. Fluconazole treatment of infected embryos and eggs promoted greater rates of survival at high doses, alongside a significant reduction of C. albicans CFUs (Chapter 4). When looking at the Candida-host interaction, we directly observed phagocytosed yeast cells within macrophages. Various detection methods were used to follow macrophages and neutrophils including Western blotting, immunostaining and histological staining (Sudan black and FITC-tyramide) allowing the monitoring of the time course of the immune cells. A biphasic response of macrophages was detected by L-plastin Western blotting, suggesting activation of two different type of macrophage: activated macrophage (M1) and alternative macrophage (M2). We also assayed reactive oxygen species (ROS) within infected embryos using a fluorescent probe (H2DCFDA), revealing the accumulation of the fluorescent probe at the sites of infection. Quantitative and qualitative analyses of the oxidative and immune response using the H2DCFDA and qPCR were also accomplished within A. dispar embryos after infection with both the WT and mutant strains of Candida albicans (WT, pmr1∆, mnt1-mnt2∆, and och1∆). The results confirmed that the mutant strains did not activate a host oxidative stress response nor immune cell accumulation when compared to WT, suggesting that the immune response is less activated against these mutants. Finally, a new transgenic line of A. dispar fish was developed using Betaactin-DsR-LoxP-GFP. The new transgenic A. dispar is suggested to be an ideal model for real time observation of host-pathogen interactions and for investigation of molecular functions of the immune response. Overall these results improve our understanding of the use of a new transparent fish model to study fungal pathogenesis and demonstrates the potential advantages of using this species in future studies of bacterial, fungal and viral pathogens at a physiologically relevant temperature for human infection. Such a model could lead us to investigate in more depth the key interactions between pathogens and their host and permit the screening and development of new antifungal therapies (that might target the pathogens directly or target the host immune system). View full metadata
The aim of the current research is to find out the extent to which algebraic thinking skills are included in the mathematics textbook for the third intermediate grade for the academic year (2020-2021) by answering the main research question:What algebraic thinking skills are included in the mathematics textbook for middle third grade?The descriptive and analytical approach was used, and to achieve the goal of the research, a list of the main algebraic thinking skills and the sub-skills were prepared, and after analyzing the content of the mathematics textbook, the stability of the analysis was verified through the analysis over time and across individuals using the Holsti equation, and
... Show MoreIn this paper, the methods of weighted residuals: Collocation Method (CM), Least Squares Method (LSM) and Galerkin Method (GM) are used to solve the thin film flow (TFF) equation. The weighted residual methods were implemented to get an approximate solution to the TFF equation. The accuracy of the obtained results is checked by calculating the maximum error remainder functions (MER). Moreover, the outcomes were examined in comparison with the 4th-order Runge-Kutta method (RK4) and good agreements have been achieved. All the evaluations have been successfully implemented by using the computer system Mathematica®10.
The aim for this research is to investigate the effect of inclusion of crack incidence into the 2D numerical model of the masonry units and bonding mortar on the behavior of unreinforced masonry walls supporting a loaded reinforced concrete slab. The finite element method was implemented for the modeling and analysis of unreinforced masonry walls. In this paper, ABAQUS, FE software with implicit solver was used to model and analyze unreinforced masonry walls which are subjected to a vertical load. Detailed Micro Modeling technique was used to model the masonry units, mortar and unit-mortar interface separately. It was found that considering potential pure tensional cracks located vertically in the middle of the mortar and units show
... Show MoreThe cross section evaluation for (α,n) reaction was calculated according to the available International Atomic Energy Agency (IAEA) and other experimental published data . These cross section are the most recent data , while the well known international libraries like ENDF , JENDL , JEFF , etc. We considered an energy range from threshold to 25 M eV in interval (1 MeV). The average weighted cross sections for all available experimental and theoretical(JENDL) data and for all the considered isotopes was calculated . The cross section of the element is then calculated according to the cross sections of the isotopes of that element taking into account their abundance . A mathematical representative equation for each of the element
... Show MoreEnrollment in kindergarten child accomplishes many positive aspects, that’s what Im sure a lot of modern educational trends in child education preschool in the importance of exposing children to a variety of sensory stimuli that contribute to impart a range of sound concepts.
Current research aims to know:
1.the level of sensory perception in the first primary grade students a sample search.
2.differences in perception of elementary first-graders with variable gender male, female)) 3.differences in perception of the first primary grade students attending and not attending kindergarten in accordance with variable attendance (attending, not attending).
school students (first grade) from attendi
... Show MoreIn the present study, semi – batch experiments were conducted to investigate the efficiency of ozone microbubbles (OMBs) in the treatment of aqueous dye solutions methylene orange under different reaction conditions such as effect of initial solution pH , ozone generation rate and initial MO-concentration. The results showed that the removal of MO by OMBs were very high at the acidic and alkaline media and upon increasing the generation rate of ozone from 0.498 to 0.83 mg/s, the removal efficiency dramatically increased from 75to 100% within 15 min. The rate of oxidation reaction followed a pseudo first- order kinetic model. The results demonstrated that OMBs is efficient in terms of the decline of methylene orange c
... Show MoreThe rapid and enormous growth of the Internet of Things, as well as its widespread adoption, has resulted in the production of massive quantities of data that must be processed and sent to the cloud, but the delay in processing the data and the time it takes to send it to the cloud has resulted in the emergence of fog, a new generation of cloud in which the fog serves as an extension of cloud services at the edge of the network, reducing latency and traffic. The distribution of computational resources to minimize makespan and running costs is one of the disadvantages of fog computing. This paper provides a new approach for improving the task scheduling problem in a Cloud-Fog environme
Construction is a hazardous industry with a high number of injuries. Prior research found that many industry injuries can be prevented by implementing an effective safety plan if prepared and maintained by qualified safety personnel. However, there are no specific guidelines on how to select qualified construction safety personnel and what criteria should be used to select an individual for a safety position in the United States (US) construction industry. To fill this gap in knowledge, the study goal was to identify the desired qualifications of safety personnel in the US construction industry. To achieve the study goal, the Delphi technique was used as the main methodology for determining the desired qualifications for constructio
... Show MoreThe unconventional techniques called “the quick look techniques”, have been developed to present well log data calculations, so that they may be scanned easily to identify the zones that warrant a more detailed analysis, these techniques have been generated by service companies at the well site which are among the useful, they provide the elements of information needed for making decisions quickly when time is of essence. The techniques used in this paper are:
- Apparent resistivity Rwa
- Rxo /Rt
The above two methods had been used to evaluate Nasiriyah oil field formations (well-NS-3) to discover the hydrocarbon bearing formations. A compu
... Show MoreDecision-making in Operations Research is the main point in various studies in our real-life applications. However, these different studies focus on this topic. One drawback some of their studies are restricted and have not addressed the nature of values in terms of imprecise data (ID). This paper thus deals with two contributions. First, decreasing the total costs by classifying subsets of costs. Second, improving the optimality solution by the Hungarian assignment approach. This newly proposed method is called fuzzy sub-Triangular form (FS-TF) under ID. The results obtained are exquisite as compared with previous methods including, robust ranking technique, arithmetic operations, magnitude ranking method and centroid ranking method. This
... Show More