Abstract Candida albicans is a commensal fungal pathogen that grows in yeast and hyphal forms in the human gut. C. albicans causes mucosal and cutaneous diseases that can result in significant mortality following systematic infections and it also exhibits drug resistance. Zebrafish have been an excellent model to investigate C. albicans infections because of their transparency and the availability of many transgenic lines. However, there is a limitation in using zebrafish as a model because the fish embryos cannot survive at 37°C therefore it is not suitable for studying Candida infections at physiological relevant human body temperature. In this thesis, the normal embryonic development of Arabian killifish (A. dispar) is investigated, revealing that embryogenesis was divided into 32 stages based on diagnostic patterns of development. A. dispar can also found to tolerate a wide range of temperatures and salinities. This suggests that A. dispar could be developed as a novel model to investigate host-pathogen interactions. The tolerance of A. dispar to high temperatures may in part be attributable to brown pigment cells with a highly fluorescent character that may have developed to allow the fish to adapt to live within extreme environmental conditions with strong sunlight and a wide range of temperatures (Chapter 3). In terms of Candida infections, this study examined A. dispar as a model to test C. albicans pathogenicity. The survival of A. dispar embryos following Candida infection showed a dose dependent relationship. We also found that A. dispar can survive longer than zebrafish after infection. Furthermore, C. albicans cells were observed to undergo a transition from yeast to hyphae at 37°C. An investigation of the ability of mutant strains of C. albicans with defects in cell wall mannosylation revealed a significant impact on virulence, host mortality, and the fishes’ immune response. The present study found that although the deletion of O- and N-mannan from the cell wall of C. albicans, affected fungal burden (attenuation), and the survival of the infected embryos per se was significantly decreased in the infections of the mutant strains compared to the WT. This data confirms the importance of the mannosylation state of the cell wall in triggering an immune recognition event (Chapter 4). A. dispar is also shown to be suitable for studying the effectiveness of 3 | P a g e antifungals. Fluconazole treatment of infected embryos and eggs promoted greater rates of survival at high doses, alongside a significant reduction of C. albicans CFUs (Chapter 4). When looking at the Candida-host interaction, we directly observed phagocytosed yeast cells within macrophages. Various detection methods were used to follow macrophages and neutrophils including Western blotting, immunostaining and histological staining (Sudan black and FITC-tyramide) allowing the monitoring of the time course of the immune cells. A biphasic response of macrophages was detected by L-plastin Western blotting, suggesting activation of two different type of macrophage: activated macrophage (M1) and alternative macrophage (M2). We also assayed reactive oxygen species (ROS) within infected embryos using a fluorescent probe (H2DCFDA), revealing the accumulation of the fluorescent probe at the sites of infection. Quantitative and qualitative analyses of the oxidative and immune response using the H2DCFDA and qPCR were also accomplished within A. dispar embryos after infection with both the WT and mutant strains of Candida albicans (WT, pmr1∆, mnt1-mnt2∆, and och1∆). The results confirmed that the mutant strains did not activate a host oxidative stress response nor immune cell accumulation when compared to WT, suggesting that the immune response is less activated against these mutants. Finally, a new transgenic line of A. dispar fish was developed using Betaactin-DsR-LoxP-GFP. The new transgenic A. dispar is suggested to be an ideal model for real time observation of host-pathogen interactions and for investigation of molecular functions of the immune response. Overall these results improve our understanding of the use of a new transparent fish model to study fungal pathogenesis and demonstrates the potential advantages of using this species in future studies of bacterial, fungal and viral pathogens at a physiologically relevant temperature for human infection. Such a model could lead us to investigate in more depth the key interactions between pathogens and their host and permit the screening and development of new antifungal therapies (that might target the pathogens directly or target the host immune system). View full metadata
In this paper, a simple fast lossless image compression method is introduced for compressing medical images, it is based on integrates multiresolution coding along with polynomial approximation of linear based to decompose image signal followed by efficient coding. The test results indicate that the suggested method can lead to promising performance due to flexibility in overcoming the limitations or restrictions of the model order length and extra overhead information required compared to traditional predictive coding techniques.
(4)
An experimental study on a KIA pride (SAIPA 131) car model with scale of 1:14 in the wind tunnel was made beside the real car tests. Some of the modifications to passive flow control which are (vortex generator, spoiler and slice diffuser) were added to the car to reduce the drag force which its undesirable characteristic that increase fuel consumption and exhaust toxic gases. Two types of calculations were used to determine the drag force acting on the car body. Firstly, is by the integrating the values of pressure recorded along the pressure taps (for the wind tunnel and the real car testing), secondly, is by using one component balance device (wind tunnel testing) to measure the force. The results show that, the average drag estimated on
... Show MoreThe construction of embankment for roadway interchange system at urban area is restricted due to the large geometry requirements, since the value of land required for such construction is high, and the area available is limited as compared to rural area. One of the optimum solutions to such problem is the earth reinforcement technique which requires a limited area for embankment construction. Gypseous soil from Al-Anbar governorate area was obtained and subjected to various physical and chemical analysis to determine it is properties. A laboratory model box of 50x50x25 cm was used as a representative embankment; soil has been compacted in five layers at maximum dry density (modified compaction) and an aluminum reinforcement strips we
... Show More
(4)
(1)
The Geological modeling has been constructed by using Petrel E&P software to incorporate data, for improved Three-dimensional models of porosity model, water saturation, permeability estimated from core data, well log interpretation, and fault analysis modeling.
Three-dimensional geological models attributed with physical properties constructed from primary geological data. The reservoir contains a huge hydrocarbon accumulation, a unique geological model characterization with faults, high heterogeneity, and a very complex field in nature.
The results of this study show that the Three-dimensional geological model of Khasib reservoir, to build the reservoir model starting with evaluation of reservoir to interpretation o
... Show MoreThe construction of embankment for roadway interchange system at urban area is restricted due to the large geometry requirements, since the value of land required for such construction is high, and the area available is limited as compared to rural area. One of the optimum solutions to such problem is the earth reinforcement technique which requires a limited area for embankment construction. Gypseous soil from Al-Anbar governorate area was obtained and subjected to various physical and chemical analysis to determine it is properties. A laboratory model box of 50x50x25 cm was used as a representative embankment; soil has been compacted in five layers at maximum dry density (modified compaction) and an aluminum reinforcement strips were i
... Show More
Gypseous soils are distributed in many regions in the world including Iraq, which cover more than (31%) of the surface area of the country. Existence of these soils, always with high gypsum content, caused difficult problems to the buildings and strategic projects due to dissolution and leaching of the gypsum caused by the action of water flow through soil mass. For the study, the gypseous soil was brought from Bahr Al-Najaf, Al-Najaf Governorate which is located in the middle of Iraq. The model pile was embedded in gypseous soil with 42% gypsum content. Compression axial model pile load tests have been carried out for model pile embedded in gypseous soil at initial degree of saturation of (7%) before and after soil satu
... Show MoreAn experimental study on a KIA pride (SAIPA 131) car model with scale of 1:14 in the wind tunnel was made beside the real car tests. Some of the modifications to passive flow control which are (vortex generator, spoiler and slice diffuser) were added to the car to reduce the drag force which its undesirable characteristic that increase fuel consumption and exhaust toxic gases. Two types of calculations were used to determine the drag force acting on the car body. Firstly, is by the integrating the values of pressure recorded along the pressure taps (for the wind tunnel and the real car testing), secondly, is by using one component balance device (wind tunnel testing) to measure the force. The results show that, the avera
... Show More
In this paper, 3D simulation of the global coronal magnetic field, which use observed line of sight component of the photosphere magnetic field from (MDI/SOHO) was carried out using potential field model. The obtained results, improved the theoretical models of the coronal magnetic field, which represent a suitable lower boundary conditions (Bx, By, Bz) at the base of the linear force-free and nonlinear force free models, provides a less computationally expensive method than other models. Generally, very high speed computer and special configuration is needed to solve such problem as well as the problem of viewing the streamline of the magnetic field. For high accuracy special mathematical treatment was adopted to solve the computation comp
... Show More
(1)