Abstract Introduction: MMP3 plays a crucial role in the process of bone erosion in the pathomechanism of rheumatoid arthritis (RA). It acts by removing the outer osteoid layer, which allows the osteoclasts to tightly connect and carry out the subsequent damage to the underlying bone. MMP3 can trigger the production of other MMPs like MMP-1, MMP-7, and MMP-9, it plays a pivotal role in the remodeling of connective tissues. Aim of the study: to assess the influence of MMP-3 serum levels and single-nucleotide polymorphisms of rs679620 in the rheumatoid arthritis patients' group in comparison to the control group. Subjects: eighty eight samples, 45 rheumatoid arthritis patients after being referred by their treating physician for regular RA test. The remaining 43 samples all represent apparently healthy people. The present study investigated the serum concentration of MMP-3 and rs679620 SNPs in the group of patients with RA, in comparison to the control group. Results: The results indicated a significant elevation in MMP-3 levels in RA patients in comparison to healthy individuals (12.75 ± 0.38 vs. 9.69 ± 0.37) and the findings of rs679620 SNPs appeared that the patient group has a non-significant increase in both allele frequency A and genotype frequency AA when compared to the control group (66.2 vs. 52.2 %; p = 0.172; OR = 1.79 and 35.3 vs. 17.4 %; p = 0.229; OR = 2.59) , but a non-significant decrease in both allele frequency C and genotype frequency CC when compared to the control group (2.94 vs. 4.4 %; p = 1.0; OR = 0.67 and 2.9 vs. 4.3 %; p = 1.0; OR = 0.67), as well as a non-significant decrease in allele frequency G and both genotypes frequency GG and AG when compared to the control group (30.9 vs. 43.5 %; p = 0.233; OR = 0.58, 0.0 vs. 8.7 %; p = 0.159; OR = 0.12 and 61.8 vs. 69.6 %; p = 0.585; OR = 0.71 ). Patients carrying the AA and AG genotype, had significantly higher serum levels of MMP-3 compared to control (P= 0.005 and 0.004) respectively. Conclusion: Rs679620 may influence joint destruction via increase MMP-3 production.
the effecth of some chemicals on growth of two azotobacter chroococcum and aniline caused significant increase of growth
Experimental results on harmonic distortions in 13.56 MHz RF Argon glow discharge using different grounded electrodes areas and electrodes spacing are presented. The experiment is carried out at four pressure values. RF power values used are between 20 and 90 watts. The results indicate significant increase in distortions at two specific values of the cone angle enclosing the two electrodes within its geometrical volume. The computation of the cone head angle gave the symmetry discharge or asymmetry as well as when the angle is small the condition is near symmetry discharge associated with decrease in the nonlinearity.
Therapeutically and prophylactically using Microspheres containing doxycycline isolated from shell of shrimp. Low molecule weight poly lactic acid was prepared. In this study, Poly lactic acid (PLA)/ poly vinyl alcohol (PVA)/poly ethyleneglycol(PEG) loading doxycycline blend solutions was prepared. Also Poly lactic acid (PLA)-Tannin blend via solvent evaporation method was prepared. Microspheres of chitosan/gelatin microsphere loading doxycycline was prepared by emulsion crosslinking technique. Both microsphere and blends were characterized by Fourier transform infrared (FTIR) spectrophotometer. The FTIR spectra were shown distinguish bands. The in vitro release of doxcycline from its matrix at pH 7 was studied. The prophylactic
... Show MoreA nanocrystalline thin films of PbS with different thickness (400, 600)nm have been prepared successfully by chemical bath deposition technique on glass and Si substrates. The structure and morphology of these films were studied by X-ray diffraction and atomic force microscope. It shows that the structure is polycrystalline and the average crystallite size has been measured. The electrical properties of these films have been studied, it was observed that D.C conductivity at room temperature increases with the increase of thickness, From Hall measurements the conductivity for all samples of PbS films is p-type. Carrier's concentration, mobility and drift velocity increases with increasing of thickness. Also p-PbS/n-Si heterojunction has been
... Show MoreBy using vacuum evaporation, thin films of the (CdS)0.75-(PbS)0.25 alloy have been deposited to form a nanocrystalline composite. Investigations were made into the morphology, electrical, optical and I-V characteristics of (CdS)0.75-(PbS)0.25 films asdeposited and after annealing at various temperatures. According to AFM measurements, the values of grain sizes rise as annealing temperatures rise, showing that the films' crystallinity has been increased through heat treatment. In addition, heat treatment results in an increase in surface roughness values, suggesting rougher films that could be employed in more applications. The prepared films have direct energy band gaps, and these band gaps increase with the increase in the degrees
... Show MoreThe objective of this research was to estimate the dose distribution delivered by radioactive gold nanoparticles (198 AuNPs or 199 AuNPs) to the tumor inside the human prostate as well as to normal tissues surrounding the tumor using the Monte-Carlo N-Particle code (MCNP-6.1. 1 code). Background Radioactive gold nanoparticles are emerging as promising agents for cancer therapy and are being investigated to treat prostate cancer in animals. In order to use them as a new therapeutic modality to treat human prostate cancer, accurate radiation dosimetry simulations are required to estimate the energy deposition in the tumor and surrounding tissue and to establish the course of therapy for the patient. Materials and methods A simple geometrical
... Show MoreBecause of Cadmium selenide quantum dots (CdSe quantum dots) has a tuning energy gap in the visible light range, therefore; it is provided a simple theoretical model for the absorption coefficient of CdSe quantum dots, where the absorption coefficient determines the extent to which the light of a material can penetrate a specific wavelength before it is absorbed. CdSe quantum dots have an energy gap can be controlled through two effects: the temperature and the dot size of them. It is found that; there is an absorption threshold for each directed wavelength, where CdSe quantum dots begin to absorb the visible spectrum at a size of 1.4 nm at room temperature for a directed wavelength 3
The embryonic development of the Mosquito fish(Gambusia affinis) eye lens was investigated using light microscopy .The results indicated that the embryonic development of the lens does not correspond to that of the non spherical lenses of terrestrial vertebrates .This study showed that a very small cavity in the lens vesicle appears during development ,but it differs from that of the mammalian lens. The most important aspect in this study is that ,the posterior edge of the simple cuboidal epithelium which covers the anterior half of the surface of the lens is situated well beyond the equatorial region of the lens .As a result , the germinal and transitional zones became closer to the posterior pole rather than the anterior pole of the le
... Show More