The objective of all planning research is to plan for human comfort and safety, and one of the most significant natural dangers to which humans are exposed is earthquake risk; therefore, earthquake risks must be anticipated, and with the advancement of global technology, it is possible to obtain information on earthquake hazards. GIS has been utilized extensively in the field of environmental assessment research due to its high potential, and GIS is a crucial application in seismic risk assessment. This paper examines the methodologies used in recent GIS-based seismic risk studies, their primary environmental impacts on urban areas, and the complexity of the relationship between the applied methodological approaches and the resulting environmental risk assessments. Using spatial analysis techniques based on the history of spatial earthquakes, fault lines, and residential complexes. This article provides map which depict the most significant seismic danger zones in Iran. The analysis reveals that the area of very dangerous and earthquake-prone zone is equal to (12%) from the residential areas, it is concentrated in the western region, adjacent to Iraq and close to the tectonic plate. The dangerous areas are concentrated in the western side of Iran, extending from the north to the south (20%), which is a fairly large percentage. As for the critical area by earthquake-prone, they are concentrated in the northern regions (23%), The medium critical areas are frequent in the centre and the north-east in Iran, and it is the largest area (26%), while the areas that less affected by the risk of an earthquake, are concentrated in the middle (17%), As for the areas that are not affected by the risk of earthquakes, (1%).
An experimental study was conducted to determine the performance of a solar electric refrigeration system. The system contained flat photovoltaic solar panel which absorbs the solar energy and convert it to electrical energy, used to run the refrigeration cycle. Two refrigeration cycles with electrical solar panel were used over a period of 12 months, the first one with classical parts known in refrigeration cycle, while the second one introduced heat exchanger which improves the coefficient of performance by saving the consumed energy. The coefficient of performance of these refrigeration cycles with compressor efficiency 85% are 2.102 and 2.57 respectively. The overall efficiency of the two systems are 18.9% and 23.13%.
This paper deals with a Twin Rotor Aerodynamic System (TRAS). It is a Multi-Input Multi-Output (MIMO) system with high crosscoupling between its two channels. It proposes a hybrid design procedure that combines frequency response and root locus approaches. The proposed controller is designated as PID-Lead Compensator (PIDLC); the PID controller was designed in previous work using frequency response design specifications, while the lead compensator is proposed in this paper and is designed using the root locus method. A general explicit formula for angle computations in any of the four quadrants is also given. The lead compensator is designed by shifting the dominant closed-loop poles slightly to the left in the
... Show MoreThis work presents an approach to deal with modelling a decision support system framework to introduce an application for decisions in medical knowledge system analysis. First aid is extremely important worldwide and, hence, a decision support framework, know as First Aid Decision Support System (FADSS), was designed and implemented to access experimental cases exerting danger to the general population, offering advanced conditions for testing abilities in research and arranging an emergency treatment through the graphical user interface (UI). The design of first aid treatment in FADSS depends on the general cases in first aid. We presented a strategy to manage first aid treatment by modelling an application (FADSS) that assists pe
... Show MoreA perturbed linear system with property of strong observability ensures that there is a sliding mode observer to estimate the unknown form inputs together with states estimation. In the case of the electro-hydraulic system with piston position measured output, the above property is not met. In this paper, the output and its derivatives estimation were used to build a dynamic structure that satisfy the condition of strongly observable. A high order sliding mode observer (HOSMO) was used to estimate both the resulting unknown perturbation term and the output derivatives. Thereafter with one signal from the whole system (piton position), the piston position make tracking to desire one with a simple linear output feedback controller after ca
... Show MoreTask scheduling in an important element in a distributed system. It is vital how the jobs are correctly assigned for each computer’s processor to improve performance. The presented approaches attempt to reduce the expense of optimizing the use of the CPU. These techniques mostly lack planning and in need to be comprehensive. To address this fault, a hybrid optimization scheduling technique is proposed for the hybridization of both First-Come First-Served (FCFS), and Shortest Job First (SJF). In addition, we propose to apply Simulated Annealing (SA) algorithm as an optimization technique to find optimal job’s execution sequence considering both job’s entrance time and job’s execution time to balance them to reduce the job
... Show MoreThis research deals with a 2D seismic structural and stratigraphic interpretation of Khan Al-Baghdadi area which is located in the western part of Iraq in Anbar governorate. Two main seismic reflectors are identified within the Silurian and Ordovician; these are the Hot_shale_1 within Akkas Formation and the Top Khabour Formation, which were deposited during the Paleozoic, based on synthetic seismogram of Akk_3 well near the study area. Time, depth, and velocity maps show the presence of two anticline structures trending east-west and located on the west side of the study area. The first is the Tulul structure (here denoted as A) and the second is denoted as B. Also, the maps show the increase in time towards the
... Show MoreIn this study, we set up and analyze a cancer growth model that integrates a chemotherapy drug with the impact of vitamins in boosting and strengthening the immune system. The aim of this study is to determine the minimal amount of treatment required to eliminate cancer, which will help to reduce harm to patients. It is assumed that vitamins come from organic foods and beverages. The chemotherapy drug is added to delay and eliminate tumor cell growth and division. To that end, we suggest the tumor-immune model, composed of the interaction of tumor and immune cells, which is composed of two ordinary differential equations. The model’s fundamental mathematical properties, such as positivity, boundedness, and equilibrium existence, are exami
... Show MoreThe main aim of this work is to investigate the existence and approximate controllability of mild solutions of impulsive fractional nonlinear control system with a nonsingular kernel in infinite dimensional space. Firstly, we set sufficient conditions to demonstrate the existence and uniqueness of the mild solution of the control system using the Banach fixed point theorem. Further, we prove the approximate controllability of the control system using the sequence method.
Refractive indices (nD), viscosities (η) and densities (r) were deliberated for the binary mixtures created by dipropyl amine with 1-octanol, 1-heptanol, 1-hexanol, 1-pentanol and tert-pentyl alcohol at temperature 298.15 K over the perfect installation extent. The function of Redlich-Kister were used to calculate and renovated of the refractive index deviations (∆nD), viscosity deviations (ηE), excess molar Gibbs free energy (∆G*E) and excess molar volumes(Vm E). The standard errors and coefficients were respected by this function. The values of ∆nD, ηE, Vm E and ∆G*E were plotted against mole fraction of dipropyl amine. In all cases the obtained ηE, ∆G*E, Vm E and ∆nD values were negative at 298.15K. Effect of carbon atoms
... Show MoreActivity recognition (AR) is a new interesting and challenging research area with many applications (e.g. healthcare, security, and event detection). Basically, activity recognition (e.g. identifying user’s physical activity) is more likely to be considered as a classification problem. In this paper, a combination of 7 classification methods is employed and experimented on accelerometer data collected via smartphones, and compared for best performance. The dataset is collected from 59 individuals who performed 6 different activities (i.e. walk, jog, sit, stand, upstairs, and downstairs). The total number of dataset instances is 5418 with 46 labeled features. The results show that the proposed method of ensemble boost-based classif
... Show More