In this work, the performance of single-mode optical fibers (SMFs) for ultraviolet (UV) radiation monitoring and dosimetry applications is presented. In particular, this work will focus on the Radiation-Induced Absorption (RIA) phenomena in the Near-Infrared domain (NIR). Such phenomena play a very important role in the sensing mechanism for SMF. Single mode fibers with a diameter of 50 µm were used for this purpose. These fibers were dipped into germanium (Ge) solution with different concentrations (1, 3, and 5 wt%) to produce the sensing part of the sensor. For all optical fiber sensors under investigation, the results indicated the dependence of the RIA on the applied UV radiation energy. Also, a redshift in peak wavelength was obtained. The influence of Ge concentration on sensing efficiency was studied and the best results were obtained with 3 wt% concentration as compared to 1 wt % and 5 wt % concentrations. The presented sensor shows good sensitivity to UV radiation which makes it possible to be applied in medical applications.
Energy efficiency is a significant aspect in designing robust routing protocols for wireless sensor networks (WSNs). A reliable routing protocol has to be energy efficient and adaptive to the network size. To achieve high energy conservation and data aggregation, there are two major techniques, clusters and chains. In clustering technique, sensor networks are often divided into non-overlapping subsets called clusters. In chain technique, sensor nodes will be connected with the closest two neighbors, starting with the farthest node from the base station till the closest node to the base station. Each technique has its own advantages and disadvantages which motivate some researchers to come up with a hybrid routing algorit
... Show MoreThe transmitting and receiving of data consume the most resources in Wireless Sensor Networks (WSNs). The energy supplied by the battery is the most important resource impacting WSN's lifespan in the sensor node. Therefore, because sensor nodes run from their limited battery, energy-saving is necessary. Data aggregation can be defined as a procedure applied for the elimination of redundant transmissions, and it provides fused information to the base stations, which in turn improves the energy effectiveness and increases the lifespan of energy-constrained WSNs. In this paper, a Perceptually Important Points Based Data Aggregation (PIP-DA) method for Wireless Sensor Networks is suggested to reduce redundant data before sending them to the
... Show MoreProgression in Computer networks and emerging of new technologies in this field helps to find out new protocols and frameworks that provides new computer network-based services. E-government services, a modernized version of conventional government, are created through the steady evolution of technology in addition to the growing need of societies for numerous services. Government services are deeply related to citizens’ daily lives; therefore, it is important to evolve with technological developments—it is necessary to move from the traditional methods of managing government work to cutting-edge technical approaches that improve the effectiveness of government systems for providing services to citizens. Blockchain technology is amon
... Show MoreA geographic information system (GIS) is a very effective management and analysis tool. Geographic locations rely on data. The use of artificial neural networks (ANNs) for the interpretation of natural resource data has been shown to be beneficial. Back-propagation neural networks are one of the most widespread and prevalent designs. The combination of geographic information systems with artificial neural networks provides a method for decreasing the cost of landscape change studies by shortening the time required to evaluate data. Numerous designs and kinds of ANNs have been created; the majority of them are PC-based service domains. Using the ArcGIS Network Analyst add-on, you can locate service regions around any network
... Show MorePhotonic Crystal Fiber Interferometers (PCFIs) are widely used for sensing applications. This work presents the fabrication and study the characterization of a relative humidity sensor based on a polymer-infiltrated photonic crystal fiber that operates in a Mach- Zehnder Interferometer (MZI) reflection mode. The fabrication of the sensor only involves splicing and cleaving Photonic Crystal Fiber (PCF) with Single Mode Fiber (SMF). A stub of (LMA-10) PCF spliced to SMF (Corning-28). In the splice regions. The PCFI sensor operation based on the adsorption and desorption of water vapour at the silica-air interface within the PCF. The sensor shows a high sensitivity to RH variations from (27% RH - 95% RH), with a change in its reflected powe
... Show MorePhotonic Crystal Fiber Interferometers (PCFIs) are widely used for sensing applications. This work presents the fabrication and the characterization of a relative humidity sensor based on a polymer-coated photonic crystal fiber that operates in a Mach- Zehnder Interferometer (MZI) transmission mode. The fabrication of the sensor involved splicing a short (1 cm) length of Photonic Crystal Fiber (PCF) between two single-mode fibers (SMF). It was then coated with a layer of agarose solution. Experimental results showed that a high humidity sensitivity of 29.37 pm/%RH was achieved within a measurement range of 27–95%RH. The sensor also showed good repeatability, small size, measurement accuracy and wide humidity range. The RH sensitivity o
... Show MoreImproving students’ use of argumentation is front and center in the increasing emphasis on scientific practice in K-12 Science and STEM programs. We explore the construct validity of scenario-based assessments of claim-evidence-reasoning (CER) and the structure of the CER construct with respect to a learning progression framework. We also seek to understand how middle school students progress. Establishing the purpose of an argument is a competency that a majority of middle school students meet, whereas quantitative reasoning is the most difficult, and the Rasch model indicates that the competencies form a unidimensional hierarchy of skills. We also find no evidence of differential item functioning between different scenarios, suggesting
... Show MoreChlamydia trachomatis is the most common of negative gram bacteria that cause sexually transmitted diseases. It affects the reproductive system in women, not the symptoms of the disease, but the most serious is the long-term effects of the reproductive system.. out of 100 women were attending different hospitals in Baghdad included the Gynaecology Departments of Women Health Center at Al-Elwyia Obstetrics Hospital . Ibn Al balady Maternity and Children's Hospital , Kamal al-Samarrai hospital Fertility Center infertility treatment and In Vitro Fertilization ( IVF ) (20 control and 80 women with infertility) DNA was extracted from the Endocervical Swabs of all infertili women, to investigate the bacteria by using Real time -PCR technique a
... Show MoreBackground: Tuberculosis (TB) is a major public health issue and a main cause of global morbidity and mortality. TB is the world's ninth leading cause of death despite the numerous treatment strategies for managing the disease.
Objective: To assess the traditional method (direct smear examination and culture) against real-time PCR as pulmonary and extrapulmonary tuberculosis laboratory diagnostic techniques.
Cases and methods: Samples were collected from (612) TB cases, (409) of whom were pulmonary tuberculosis (PTB) and (203) were extrapolmonary tuberculosis (EPTB). The cases were seeking care at the Specialized Chest and Respiratory Disease Center/ National Reference Laboratory for Tuberculosis (NRL) in Baghdad, during the period
Background: Ionizing radiations are hazardous agents in the workplace, since all forms of ionizing radiation produce some type of injury that is incurable. Therefore, protection against ionizing radiation exposure can play an important role in the health of workers.
Objectives: is to evaluate the application of radiation protection among radiation workers at X-ray department in Erbil hospitals.
Patients and methods: Six hospitals (General and Private) were visited. Samples of 110 were randomly selected among 135 radiation workers, 47 (42.3%) female and 63 (57.3%) male Data was collected through structured questionnaires. The surveyed data was coded and analyzed by using MS Excel software, and SPSS 18 f