The objective of the present study is to verify the actual carious lesion depth by laser
fluorescence technique using 650 nm CW diode laser in comparison with the histopathological
investigation. Five permanent molar teeth were extracted from adult individuals for different reasons
(tooth impaction, periodontal diseases, and pulp infections); their ages were ranging from 20-25 years
old. Different carious teeth with varying clinical stages of caries progression were examined. An
experimental laser fluorescence set-up was built to perform the work regarding in vitro detection and
quantification of occlusal dental caries and the determination of its actual clinical carious lesion depth by
650 nm CW diode laser (excitation wavelength (λexcit.) = 669 nm). Five teeth were sent to
histopathological examination to confirm the efficacy of laser fluorescence technique for the
determination of actual carious lesion depth. The results are leading to the detection of carious lesions for
different depths. The deepest carious lesions revealed high fluorescence intensity. Based on these
findings; it was concluded that 650 nm CW diode laser (λexcit. = 669 nm 40 mW) is a suitable and a
reliable tool for caries diagnosis and depth assessment. Histopathological findings for the estimation of
actual carious lesion depth revealed a good correlation with that of laser fluorescence technique.
In this work Laser wireless video communication system using intensity modualtion direct
detection IM/DD over a 1 km range between transmitter and receiver is experimentally investigated and
demonstrated. Beam expander and beam collimeter were implemented to collimete laser beam at the
transmitter and focus this beam at the receiver respectively. The results show that IM/DD communication
sysatem using laser diode is quite attractive for transmitting video signal. In this work signal to noise
ratio (S/N) higher than 20 dB is achieved in this work.
This research aims to design a high-speed laser diode driver and photodetector, the result is the
design of the high-speed laser diode driver with a short pulse of 10 ns at 30 KHz frequency and the
delivered maximum pulse voltage is 5.5 mV. Also, its optical output power of the laser diode driver is
about 2.529 mW for the centroied wavelength 1546.7 nm with FWHM of 286 pm and (1270-1610) nm.
The design of the circuit based on bipolar transistor where the input pulse signal is simply generated by
an arduino kit with 15 kHz frequency and then compensated to trigger to small signal amplifier which
was is simply NPN C3355 transistor and the output is a current driver to the laser diode. OptiSystem
software and Electronic
In this paper an estimator of reliability function for the pareto dist. Of the first kind has been derived and then a simulation approach by Monte-Calro method was made to compare the Bayers estimator of reliability function and the maximum likelihood estimator for this function. It has been found that the Bayes. estimator was better than maximum likelihood estimator for all sample sizes using Integral mean square error(IMSE).
In this paper we report the use of supersonic jet laser induced fluorescence (LIF) spectroscopy to facilitate the study of the spectra of some organometallic sandwich compounds particularly the metallocenes. The charge-transfer processes within these compounds, especially ligand to metal charge transfer within decamethylrhenocene ( - C5 Me5)2 Re were of particular interest. The spectrum shows a high degree of structures, indicating that there are several levels populated and these molecules are able to undergo many possible transitions
Background: Breast cancer is one of the common malignancies among women worldwide. Human papillomavirus (HPV) infections have been linked to many human cancers in addition to cervical cancer and one of them is breast cancer.
Objective: To investigate the presence of human papilloma virus type 6 and type 11in breast cancer tissue specimens by in situ hybridization technique.
Patients and Methods: Thirty four formalin-fixed, paraffin embedded tissue blocks from breast cancer patients were obtained from the archives of the pathology laboratory of Al-Yarmouk Teaching Hospital from January 2011 to July 2012. In addition formalin-fixed, paraffin embedded blocks tissue for twenty fibroadenoma of breast were collected and used as control g
Incident laser power and concentration effects on fluorescence emission from DCM dye in PMMA polymer have been investigated. Different concentrations of the dye were used. It was found that the fluorescence intensity increased with increasing of the concentration of the dye, with a red shift. In addition, it was found that the fluorescence intensity increased with the increase of the incident laser power I0.
Background: The role of Human papillomaviruses (HPV) in the etiology of ovarian cancer remains unclear and the results are controversial. Several studies have verified the presence of HPV DNA in both malignant and benign ovarian tumors.
Objectives: Determine the percentage of detection of HPV high (16&18) and low risk types (6&11) in surface epithelial ovarian carcinoma compared to benign and control groups.
Materials And Methods: Molecular detection and genotyping of HPV DNA were performed in 76 ovarian tissue blocks by using in situ hybridization (ISH) technique for detecting and localization of high risk HPV (16 and 18) and low risk HPV (6&11) types.
Results: The presence of ISH signals fo
(1)
Background: Recurrent aphthous stomatitis is a common condition characterised by recurrent episodes of oral ulceration. Genetic factors have been implicated by numerous studies on the association of recurrent aphthous stomatitis and the genetically determined HLA subtypes.
Objectives: Current study was established to shed light on the possible association of HLA class I and II alleles with recurrent aphthous stomatitis in Iraqi patients.
Subjects and Methods: The study included 55 subjects: 30 recurrent aphthous stomatitis patients and 25 apparently healthy subjects as control. Polymerase chain reaction-specific sequence primers (PCR- SSP) assay was conducted to assess HLA- typing.
Results: The present s
(1)
A fuzzy logic approach (FLA) application in the process of stud arc welding environment was implemented under the condition of fuzziness input data. This paper is composed of the background of FLA, related research work review and points for developing in stud welding manufacturing. Then, it investigates thecase of developingstud arc welding process on the controversial certaintyof available equipment and human skills.Five parameters (welding time, sheet thickness, type of coating, welding current and stud shape) were studied.A pair of parameter was selected asiteration whichis welding current and welding time and used fo
... Show MoreThe purpose of this study is to investigate the histopathological response of dentinopulpal
response of human teeth to the Er: YAG laser cavity preparation in comparison with the conventional
class I cavity preparation. Thirty five sound human upper and lower first premolar teeth which were
needed to be extracted for orthodontic purposes were used in the study. Regarding to the method of
cavity preparation, the teeth were grouped into three groups; Group1; Control group which consists of
seven sound teeth without cavity preparation, Group2; Conventional cavity preparation group and group
3; Er: YAG laser cavity preparation group. Each of Group2 and3 consists of fourteen teeth that is
subdivided into: A. 7teeth that e