Investigation of the performance of integrated intelligent models to predict the roughness of Ti6Al4V end-milled surface with uncoated cutting tool
(4)
(3)
Publication Date
Fri Dec 08 2023
Journal Name
Iraqi Journal Of Science
Determination of Atenolol in pharmaceutical formulations by continuous flow injection analysis via turbidimetric (T180o) and scattered light effect at two opposite position (2N90o ) using Ayah 4SW-3D-T180 -2N90 -Solar - CFI
Atenolol
Spectrophotometry
Turbidity & Nephelometry
Flow injection analysis
A simple, rapid and sensitive method for the analysis of Atenolol in pure and pharmaceutical preparation as an alternative analytical procedure were developed by continuous flow injection analysis via turbidimetric (T180o) and scattered light effect at two opposite position (2N90o). The method is based upon the formation of white precipitate for the ion pair compound by phosphomolybidic acid with Atenolol in aqueous medium. The precipitate is measured via the attenuation of incident light and scattering of the incident light in two opposite direction namely +90o and -90o angle were measured. Chemical and physical parameters were investigated. The linearity of Atenolol is ranged from (0.1-11) mmol.L-1, with correlation coefficient r=0.993
... Show MorePublication Date
Tue Dec 13 2022
Journal Name
Dental Hypotheses
Comparative Evaluation of Marginal Microleakage Between Bulk-Fill, Preheated Bulk-Fill, and Bulk-Fill Flowable Composite Resins Above and Below Cemento-Enamel Junction Using Micro-Computed Tomography: An In Vitro Study
Bulk fill composite resin
bulk fill flowable
micro-CT
microleakage
preheated composite resin
Objective: The aim of this study was to compare the marginal microleakage between bulk-fill, preheated bulk-fill, and bulk-fill flowable composite resins above and below cemento-enamel junction (CEJ) using micro-computed tomography. Methods: Sixty freshly extracted premolar teeth were prepared with a slot shaped cavities of a total of 120 Class II: 3mm (bucco-lingual), 2mm (mesio-distal) with mesial-gingival margin located 1mm coronal to CEJ, and distal gingival margin located 1mm apical to the CEJ. The samples were randomly divided into two main groups according to the restorative material (Tetric EvoCeram and 3M Filtek), and each group was further sub-divided into three subgroups according to the consistency (bulk fill, preheated bulk fil
... Show More
(5)
(3)
Publication Date
Sun Apr 30 2017
Journal Name
Journal Of Engineering
Experimental Study on Heat Transfer and Friction Factor Characteristics of Single Layer Graphene Based DI-water Nanofluid in a Circular Tube under Laminar Flow and Different Heat Fluxes as Boundary Conditions
convective heat transfer
graphene nanofluid
laminar flow
pressure drop
performance factor
An experimental study was performed to estimate the forced convection heat transfer performance and the pressure drop of a single layer graphene (GNPs) based DI-water nanofluid in a circular tube under a laminar flow and a uniform heat flux boundary conditions. The viscosity and thermal conductivity of nanofluid at weight concentrations of (0.1 to 1 wt%) were measured. The effects of the velocity of flow, heat flux and nanoparticle weight concentrations on the enhancement of the heat transfer are examined. The Nusselt number of the GNPs nanofluid was enhanced as the heat flux and the velocity of flow rate increased, and the maximum Nusselt number ratio (Nu nanofluid/ Nu base fluid) and thermal performance factor
... Show MorePublication Date
Sun Aug 13 2017
Journal Name
Ibn Al-haitham Journal For Pure And Applied Sciences
In vivo study of compounds 3-(acetyl Salicyloyl)-5,6 –Oisopropylidene-L-ascorbic acid ,2,3- (acetyl Salicyloyl)-5,6 –O-isopropylidene-L-ascorbic acid and 2,3,5,6Tetra(acetyl Salicyloyl)-L-ascorbic acid
In vivo study was made for the coumpounds 3-(ocetyl Salicyloyl)-5,6-O-isoprpy lideneL-ascorbicocid,2,3-(acetyl Salicyloyl )-5,6-o- isopropylidene-L-ascorbic acid and 2,3,5,6(acetyl Salicyloyl )-L- ascorbic acid .And a measurement was mod for the concentration of the liberated aspirin in blood samples a fter (2,3,4,6,8,10) hours of the initial dose for the animal .The results showed that the highest concentration of aspirin was after four hours of giving the dose to the animal which is in accordance with pharmacokinetics studies
Publication Date
Wed Jul 01 2020
Journal Name
International Journal Of Pharmaceutical Research
(2)
(1)
Publication Date
Sat Sep 23 2017
Journal Name
Ibn Al-haitham Journal For Pure And Applied Sciences
Synthesis and Characterization of New ligand ' ((2-{1..,[(2-hyd_roxy;..benzyli_dene)-hydrazono]- ethyl} benzen_e-l, 3, s--moll and ItComplexes W·itll. (Mn.(11 Fe(n), Cd<11J, a-nd Hg(n).) Tons
In :the _pr sent _paper we report ths. ynthesis ·of a new li:ga!!d..
[f4LJ [{'2 {1-'[(2-hyd•:0xy-.ben:zy1i.den·e)..,bxcJrazanci}:etby-l }benzerieÂ
J,5 t;rtiol .aad its complexes ·w-ith '('Mlif(1 J Fev 1 ), ed(J'l), and. :f.::I:g 01>-)
The ligand \VS preP..ated rin tWo steps' • fp I t}Je nrst stea -soJutiQil Qf
-saUcyla[deeyeq. ip methatt:oJ . re3ctcd lU1der reflux
... Show MorePublication Date
Mon Dec 25 2017
Journal Name
Iraqi Journal Of Pharmaceutical Sciences ( P-issn 1683 - 3597 E-issn 2521 - 3512)
Extraction, Identification and Isolation of B-sitosterol from Iraqi Wild Awsaj plant (Lycium barbarum) Using UAE (Probe and Bath) and two isolation technique (HPTLC and PHPLC): B-sitosterol in Iraqi Awsaj plant
Key words: Awsaj
ultrasound assisted extraction (UAE)
B-sitosterol
high performance thin layer chromatography (HPTLC)
preparative high performance liquid chromatography (PHPLC).
Awsaj (Lycium barbarum) is a plant belong to family Solanaceae serves as a good source of bioactive compounds like phytosterols which have many important biological activity. Literature survey available so far revealed that there was no studies about Iraqi wild Awsaj phytosterols especially B-sitosterol, there for the objective of this study was to examine the efficiency of ultrasound assisted extraction (probe and bath) as compared to the conventional (Soxhlet) extraction method for extraction of phytosterols especially B-sitosterol from fruits, leaves, stems and roots of Iraqi wild Awsaj plant. This goal was achieved by comparing the extraction mass yield, also by a quick and easy approach for identification and quantification of bioac
... Show More
Publication Date
Sat Jun 03 2023
Journal Name
Iraqi Journal Of Science
Effect Effect Effect Effect Effect Effect Effect of Thickness on Some Physical PropertiesThickness on Some Physical PropertiesThickness on Some Physical PropertiesThickness on Some Physical PropertiesThickness on Some Physical Properties Thickness on Some
Fe2O3 thin films
PLD
XRD
AFM
Absorption Spectra
The effect of thickness variation on some physical properties of hematite α-Fe2O3 thin films was investigated. An Fe2O3 bulk in the form of pellet was prepared by cold pressing of Fe2O3 powder with subsequent sintering at 800 . Thin films with various thicknesses were obtained on glass substrates by pulsed laser deposition technique. The films properties were characterized by XRD, and FT-IR. The deposited iron oxide thin films showed a single hematite phase with polycrystalline rhombohedral crystal structure .The thickness of films were estimated by using spectrometer to be (185-232) nm. Using Debye Scherrerś formula, the average grain size for the samples was found to be (18-32) nm. Atomic force microscopy indicated that the films had
... Show MorePublication Date
Sat Sep 01 2018
Journal Name
Polyhedron
Novel dichloro (bis {2-[1-(4-methylphenyl)-1H-1, 2, 3-triazol-4-yl-κN3] pyridine-κN}) metal (II) coordination compounds of seven transition metals (Mn, Fe, Co, Ni, Cu, Zn and Cd)
The 1
3-dipolar cycloaddition “click” reaction between an azide and an alkyne to give a 1
2
3-triazole was reported by Huisgen in 1961 [1]. In 2002 the Copper(I)-catalyzed Azide-Alkyne Cycloaddition (CuAAC) to prepare a 1
2
3-triazole was reported [2]
[3]. The existence of relatively basic nitrogen atoms in the 1
2
3-triazole rings
and the possibility of introducing additional donor groups in the substituents (Fig. 1)
made the CuAAC “click” reaction an attractive method to prepare differently substituted 1
2
3-triazoles. These compounds have been used as ligands to coordinate to various metal ions that display a range of applications such as in electrochemical and photochemical studies
in supramolecular chemistry
magnetism
metal-ion sensing and catalysis [4]. The reasons for the success of the “click” reaction
is that it is easy to carry out and is widely applicable. It is not affected by a variety of functional groups
and can be carried out with a variety of Cu(I) catalysts and solvents
including aqueous conditions. The Cu(I) catalysts overcome the high activation energy barrier of the non-catalyzed Huisgen reaction by changing the mechanism of the reaction. A large variety of copper catalysts can be used for the CuAAC reaction
on condition that the maximum concentration of Cu(I) species is generated during the reaction. The pre-catalyst can be a Cu(II) salt (usually CuSO4) together with a reducing agent (often sodium ascorbate) or a Cu(I) compound in the presence of a base or amine ligand and a reducing agent to prevent oxidation to Cu(II). Some strong oxidising cupric salts or complexes such as Cu(OAc)2 also work. The solvent is very flexible from organic to aqueous
with the most commonly used combination water + an alcohol (t-BuOH
MeOH or EtOH). The key role of the solvent or solvent mixture is to solubilize the substrates and Cu(I) catalyst in order to ensure rapid reactions. Such aqueous conditions are very useful for biochemical conjugations
as well as for organic syntheses.
We recently reported on the synthesis of a series of differently substituted 1
2
3-triazole chromophores
the substituted 2-(1-phenyl-1H-1
2
3-triazol-4-yl)pyridine ligands [5]
see Fig. 2 middle
with substituents R = H (L1)
CH3 (L2)
OCH3 (L3)
COOH
F
Cl
CN
CF3
O(CH2)3CH3 and N(CH3)2. These versatile ligands were found to coordinate to various first row transition metals
such as manganese
cobalt and nickel [6]. Here we extend the series to include more first row transition metal(II) coordination compounds
iron
copper and zinc
as well as a second row transition metal(II) coordination compound
cadmium
containing the 2-(1-(4-methyl-phenyl)-1H-1
2
3-triazol-1-yl)pyridine chromophore (Fig. 2 right with R = CH3). This series of seven novel coordination compounds is the first series of pyridyl-triazole based transition metal coordination compounds where seven different transition metals are coordinated to the same 1
2
3-triazole chromophore
namely 2-(1-(4-methyl-phenyl)-1H-1
2
3-triazol-1-yl)pyridine.
Publication Date
Tue Jan 01 2019
Journal Name
Inorganica Chimica Acta
Synthesis, characterisation and electrochemistry of eight Fe coordination compounds
containing substituted 2-(1-(4-R-phenyl-1H-1,2,3-triazol-4-yl)pyridine ligands, R = CH3,
OCH3, COOH, F, Cl, CN, H and CF3.
(1
2
3-Triazol-4-yl)pyridine
Redox potential
Iron
DFT
Eight different Dichloro(bis{2-[1-(4-R-phenyl)-1H-1,2,3-triazol-4-yl-κN3]pyridine-κN})iron(II) compounds, 2–9, have been synthesised and characterised, where group R=CH3 (L2), OCH3 (L3), COOH (L4), F (L5), Cl (L6), CN (L7), H (L8) and CF3 (L9). The single crystal X-ray structure was determined for the L3 which was complemented with Density Functional Theory calculations for all complexes. The structure exhibits a distorted octahedral geometry, with the two triazole ligands coordinated to the iron centre positioned in the equatorial plane and the two chloro atoms in the axial positions. The values of the FeII/III redox couple, observed at ca. −0.3 V versus Fc/ Fc+ for complexes 2–9, varied over a very small potential range of 0.05 V.
... Show More